go top

网络释义专业释义

  bearing stratum

二、工业与民用建筑的主要工程地质问题 11/106 理想的持力层(bearing stratum): 岩性均一,结构致密,强度高,层厚大而分布均 匀,含水量不大,处在硬塑至可塑的稠度状态,变 形量小等非新近沉积的土层。

基于472个网页-相关网页

  supporting layer

灰岩地区桩基础的选型以及施工措施的认识 关键词:灰岩; 持力层; 桩基 [gap=562]Keywords: limestone;supporting layer; Pile foundation

基于100个网页-相关网页

  three

岩地层钻孔桩施工论文发表流程_【建筑学术论文发表】_【建筑职称论文发表】_建筑职称论文_建筑论文网 关键词:角砾岩;钻孔桩;持力层 [gap=313]Keywords: breccia; Drilling pile; three

基于16个网页-相关网页

  bearing layer

复杂桩端持力层下单桩承载能力优化设计-建筑结构 关键词]持力层;静载试验;单桩承载力;优化设计 [gap=959]Keywords:bearing layer; static load test; bearing capacity of single pile; optimal design

基于16个网页-相关网页

短语

基桩持力层 Foundation pile-supported load bed

桩端持力层 bored piles

地基持力层 include the foundation

持力层软化 bearing stratum softening

 更多收起网络短语
  • bearing stratum - 引用次数:21

    So the study of loess dynamics is very important, a lot research work do on loess site dynamics in recent years, but little on bearing stratum under pile toe.

    因此黄土的动力响应研究至关重要,近年来对黄土场地土层动力响应的研究很多,但对桩端黄土持力层的动力响应研究却涉及很少。

    参考来源 - 桩端黄土持力层对地震波的响应研究
    supporting course - 引用次数:7

    When the Building ground subgrade soil which do not meet the ground bearingcapacity and deformation , yet not demand the subgrade treatment . Then ,use deeplevel foundation firm stratum or rock formation to subgrade supporting course.

    当建筑场地地基土质不能满足建筑物对地基承载力和变形的要求,也不宜采用地基处理等措施时,往往需要以地基深层坚实图层或岩层作为地基持力层,采用深基础方案。

    参考来源 - 打桩过程中桩周土体的固结特性研究
  • supporting layer
    bearing stratum
  • bearing stratum - 引用次数:2

    参考来源 - 期刊学术社区
  • bearing stratum

·2,447,543篇论文数据,部分数据来源于NoteExpress

双语例句

  • 介绍了某工程人工挖孔桩桩持力层载荷试验及其结果

    This paper introduces the method and result of load test on supporting layer of man-made hole pile.

    youdao

  • 本文介绍人工挖孔桩桩端持力层载荷试验方法试验结果

    This paper presents the method and result of load test on supporting layer of man-made hole pile.

    youdao

  • 结果表明抗拔曲线形状持力层岩石风化程度桩的嵌岩深度有关

    It is shown that the shape of curves is related to the rock weathering of bearing strata and rock-socketed depth.

    youdao

更多双语例句

百科

持力层

土木工程结构设计中,在地基基础设计时,直接承受基础荷载的土层称为持力层。在土力学计算中,持力层受到的压力是持续减少的,到若干深度以后压力就可以忽略不计,具体深度要经过计算才知道。承受压力的这一部分叫做持力层,持力层以下的部分叫做下卧层。也就是说,根据承受荷载的不同,持力层和下卧层也是不同的。

详细内容

以上来源于: 百度百科
$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定