多次切割技术 Multiple Cutting Technology
Based on the algorithm, the wire path of multiple-cut for the ruled surface is generated in 4-axis WEDM.2.
根据直纹面的特点,研究了直纹面一次切割电极丝中心轨迹的生成;在此基础上,研究了直纹面多次切割电极丝中心轨迹的生成。
参考来源 - 电火花线切割加工轨迹生成及仿真技术研究·2,447,543篇论文数据，部分数据来源于NoteExpress
良好的电极丝动态性能是高速走丝多次切割加工的基础。
A good dynamic stability is the basis of multiple cut on machine tool of WEDM with high wire travelling speed.
本文提出了一种可满足多次切割需要的尖角策略控制技术。
The control technology of sharp coner strategy which can meet multi-cutting requirements is put forward in this paper.
多次切割后加工光洁度最高可达1um，可与慢走丝机床媲美。
Cuts the postprocessing smooth finish to be highest many times may reach 1um, may with walk the silk engine bed setoff slowly.
应用推荐