(1)缓慢改变激励量法。测试时继电器线圈施加的激励量由零逐渐增加到动作值,再由动作值升至额定值,逐渐降至返回值,然后由返回值降低到零。 (2)突然施加激励量法。测试时首先调整好规定的动作值,然后突然施加于继电器线圈,再升至额定值,由额定值突然降低到规定的返回值。对于突然施加激励量法的试验,应根据继电器动作情况来决定其结果是否合格。
定义 中文名称: 动作值 英文名称: operating value 定义: 在规定条件下使继电器动作(从初始状态改变到动作状态)的输入量(激励量)的值。 应用学科: 电力(一级学科);继电保护与自动化(二级学科) 以上
基于180个网页-相关网页
... responder-beacon 应答器信标 responding value 动作值 response alarm 越超警报响应信号 ...
基于20个网页-相关网页
... 动作后 operated 动作值 pick-upvalue;operatingvalue 动作值的变差(离散值) variation(diversity)ofoperatingvalue ...
基于12个网页-相关网页
报警动作值 alarm operation value
不动作值 non-operating value ; [电] non-operate value
继电器未动作值 relay non-operate value
动作值函数 action-value function
继电器末动作值 relay non-operate value
动作值的变差 variation of operating value
继电保护动作值 action value of relay protection
动作温度标准值 Standard value of switching temperature
动作阀值 operation threshold
按设计的整定值,检验继电器实际动作值。
Check actual operation value of the relay according to set value.
复核继电器的动作值。
对过量参数值由低值逐渐升至动作值,欠量参数值由额定值降至动作值。
Excessive parameters, increase gradually from low value to operation value, less of parameter values decrease from rated value to operation value.
I get to the end of the loop, and I actually do a little bit of wasted motion there. And the little bit of wasted motion is, I take the value at i, store it away temporarily, take the value where min index is pointing to, put it back in there, and then swap it around.
我走到了循环的末尾,事实上我做了多余的动作了,有点多余的是我把i的值,临时保存起来了,看看MinIndex指向的值,放回到哪里,然后再交换。
应用推荐