To low drawing in flange part, the blank holder can be used as punch, and the effect is good.
对于凸缘部位的浅拉深,采用压边圈兼作浅拉深凸模的作用,取得较好的效果。
The differences of stress state between extrusion-flanging and traditional flanging, and the influences of curvature radius of burring punch on flange height were analyzed.
分析了挤压翻边与传统翻边应力状态的不同之处,以及翻边凸模的冲头曲率半径对翻边效果的影响。
应用推荐