design post-processing 设计后处理
This paper expounds the design of processing techniques before hole-boring on the cylinder of upright post and hoisting jack used in the hydraulic support.
阐述了液压支架所用立柱、千斤顶的缸筒在上深孔钻镗床进行镗孔、滚压之前必须进行的加工工艺的设计。
In this paper, the studies on programmable gain is described detailed including the hardware structure, the software design and information post processing.
文中主要阐述可编程增益的研究，包括硬件构成、软件设计和信息后处理。
The improvement of tool design and development of data post-processing method should be aimed at this distorting mechanism, otherwise the real situation of thin layer will not be reconstructed.
必须针对这种失真的机理来改进仪器设计和开发后处理方法，才可能重现薄层的真实情况。
应用推荐