准/规范中文名: 流体技术.O型密封圈.型式及表面误差 标准/规范英文名: Fluid systems; O-rings; quality acceptance criteria 批准日期: 1984-12 翻译进度: 待翻译 标准号&标准中文名&标准英文名: DIN 3
基于26个网页-相关网页
Seals and O rings 防漏和O型密封圈
Rubber O-rings 橡胶制环形密封圈
Elastomeric O-rings 弹性O型圈
Oil pump piston o-rings 油泵柱塞O型圈
Sulzer gripper booster O-rings 苏尔寿增压器O型圈
Sewage hole cylinder head O-rings 缸盖排污孔O型圈
O-rings housings O型密封圈装配槽
O -rings O型圈
o rings o形圈
TSM-α-I model was firstly recommended for sealing engineering. The parameters of these models can be obtained by finite analysis methods based on a material constitutive relationship or straightly by cyclic compressing-springback tests of a few O-ring specimens.
这些模型的参数可根据材料本构关系应用有限元方法确定,也可以根据“O”形环压扁试验确定。
参考来源 - 金属环密封特性及N18核燃料包壳管低周疲劳研究In this paper, a detailed car body rubber seal structure, such as automotive sealants, rubber, as well as used cars sealing structure, such as the O-ring, oil seal and so on.
本文详细的阐述了轿车车身橡胶密封结构,如车用密封胶,橡胶条以及轿车常用的密封结构,如O型圈、油封等。
参考来源 - 轿车车身密封结构及其仿真·2,447,543篇论文数据,部分数据来源于NoteExpress
N a rubber ring used in machinery as a seal against oil, air, etc O形密封圈
应用推荐