当前查询结果是否对您有帮助
go top

shear strength

  • 切变强度

网络释义专业释义英英释义

  [力] 剪切强度

13、剪切强度(shear strength),在平行于胶层的载荷作用下,胶接试样破坏时,单位胶接面所承受的剪切力。用mpa表示。

基于4341个网页-相关网页

  [力] 抗剪强度

航海及海运专业英语词汇S-254-SCIdict学... ... 剪切强度 shear strength 抗剪强度 shear strength 舷弧型深比 shear-depth ratio ...

基于855个网页-相关网页

  切变强度

物理学英汉词汇 青岛雅文翻译公司 ... shear modulus切变模量,剪模量,剪切模量 shear strength切变强度,剪切强度 shear stress切应力,剪应力 ...

基于221个网页-相关网页

  屈服强度

钻井行业翻译词汇-专业钻井行业翻译公司 ... 区块block 屈服强度shear strength 屈服值yielding point ...

基于217个网页-相关网页

短语

shear r strength 剪切强度

shear transfer strength 剪力传递强度

apparent shear-strength 表现抗剪强度

twin shear unified strength 双剪统一强度

shear yield strength 剪切屈服极限

twin shear stress strength 双剪应力强度

shear bond strength 剪切强度 ; 剪切力 ; 粘结强度测试 ; 抗剪切强度

compressive shear adhesive strength 压剪粘接强度

Joint shear resistant strength 节理抗剪切强度

 更多收起网络短语
  • 抗剪强度 - 引用次数:382

    ( Lime fly ash is light in unit weight; high in shear strength and pull out coefficient, so it is an ideal fill material.

    ( 石灰粉煤灰自重轻、抗剪强度和拉拔系数高,因此石灰粉煤灰是理想的土工合成材料加筋土工程的轻型填料。

    参考来源 - 土工合成材料加筋的试验研究和有限元分析
    抗剪承载力 - 引用次数:109

    The test research of shear strength of steel reinfOrcement high-strength con-crete short columns is carry out.

    研究钢骨高强混凝土框架短柱的抗剪承载力

    参考来源 - 钢骨高强混凝土短柱及高强混凝土短柱力学性能的研究
    受剪承载力 - 引用次数:70

    The test results show that the shear strength is obviously increased and the ductility of these beams is also improved.

    试验研究表明,采用碳纤维布加固对提高钢筋混凝土梁的受剪承载力有明显的效果,并可改善钢筋混凝土梁的变形性能,增强其变形能力。

    参考来源 - 碳纤维布加固钢筋混凝土梁受剪性能试验研究
    剪切强度 - 引用次数:35

    The relationship between the shear strength of bonding layer and its normal stress was expatiated under low hydrostatic stress-state.

    并从破坏机理上分析了影响粘结层剪切强度的因素;及对低静水应力状态下,粘结层剪切强度与其上作用的正应力关系进行了阐述。

    参考来源 - 老化病害混凝土结构质量评估及粘结加固中的基础问题研究
  • 抗剪强度 - 引用次数:153

    Through laboratory tests and large on-site shear tests, studied the shear strength characteristics of the structure plane.

    通过室内试验和现场大试验,研究了红层软岩结构面抗剪强度特性。

    参考来源 - 红层软岩开挖边坡致灾机理及防治技术研究
    剪切强度 - 引用次数:34

    参考来源 - 红层软岩开挖边坡致灾机理及防治技术研究
    抗剪承载力 - 引用次数:5

    According to the calculated results, the influence of the main factors to the shearstrength of box-girder bridges including the shear strength, principal compressivestress of concrete and deformation is analyzed.

    根据有限元模型计算结果,详细分析跨比、配箍率、腹板厚度对箱形桥梁的抗剪承载力、混凝土主压应力、腹筋应力等的影响。

    参考来源 - 箱形桥梁抗剪性能数值分析及简化计算
  • 剪切力 - 引用次数:10

    The data was statistically dealed with by SPSS 11.5 to analyze the difference of groups and the correlation of loading time and shear strength.

    所得各组数据采用SPSS 11.5统计软件比较各组间剪切力的差异有无显著性,并对愈合时间和剪切力进行相关性分析。

    参考来源 - 微型支抗种植体加载时机的动物实验研究
  • 抗剪参数 - 引用次数:2

    Through the study of mechanical experiment, the uniaxial compression strength indices and shear strength parameters are put forward, which indicate that several typical soft rocks have strong aeolotropy, and that strength parameters are all very low.

    通过多项力学试验研究,给出单轴压强度指标及抗剪参数,得出坝区几种典型岩组具有强烈的各向异性,其变形及强度参数均较低。

    参考来源 - 软岩特性研究及其对边坡影响的敏感性分析
    抗剪强度
  • 剪切强度 - 引用次数:1

    参考来源 - 压缩速度对电流变液抗压强度影响的实验研究
    风切强度
    抗切强度
    抗剪强度
  • 抗剪断强度
    抗剪强度
    剪切强度
  • 剪切强度

·2,447,543篇论文数据,部分数据来源于NoteExpress

Shear strength

  • The shear strength of a discontinuity in a soil or rock mass may have a strong impact on the mechanical behavior of a soil or rock mass. The shear strength of a discontinuity is often considerably lower than the shear strength of the blocks of intact material in between the discontinuities, and therefore influences, for example, tunnel, foundation, or slope engineering, but also the stability of natural slopes.

以上来源于: Wikipedia

 柯林斯英汉双解大词典 

shear strength

  • 1. 

    N the degree to which a material or bond is able to resist shear 抗剪强度

双语例句

  • In this article we do not give any specific shear strength, just some relative values.

    篇文章我们给予任何具体抗剪强度只是一些相对价值

    danci.911cha.com

  • Bonding temperature, bonding time and interlayer thickness have an obvious effect on the shear strength of the joints.

    连接温度连接时间中间层厚度接头抗剪强度具有较明显影响

    dict.cnki.net

  • In the range of incident velocities near to the perforation limit velocity(V50) , this mechanism depends on thickness and interlaminar shear strength of composite plate.

    接近穿孔极限速度入射速度V50范围机制依赖复合材料厚度中间层剪切强度

    dict.cnki.net

更多双语例句
$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定