延伸率δ指的是描述材料塑性性能的指标——延伸率δ和截面收缩率。延伸率即试样拉伸断裂后标距段的总变形ΔL与原标距长度L之比的百分数:δ=ΔL/L×100%。
除此以外,对胶粘剂固化后的玻璃化温度(Tg)及延伸率(Percentage elongation)也有一定要求,玻璃化温度接近或低于室温较好,延伸率最好在10%以上,这样可以有效地吸收应力,更不致因玻璃化温度太高而造成磁...
基于696个网页-相关网页
... percentage change百分比变动 elongation percentage延伸率;伸长率... percentage error百分误差;误差百分率...
基于356个网页-相关网页
Ⅳ级钢筋强度太高,不适宜作为钢筋混凝土构件中 的配筋,一般冷拉后作预应力筋 延伸率(Percentage of elongation):d 5 =25、16、14、 10%,直径8~40。
基于356个网页-相关网页
延伸率试验 alongation test
断裂延伸率 tension set ; elongation at fracture ; Elongation
极限延伸率 Elongation ultimate ; Elongation
松紧带有效延伸率 Limit Of Useful Extension
机械延伸率 Mechanical elongation ; Machine Elongation rate ; Ratio of drawing draft
破裂延伸率 Break elongation
磁带延伸率 tape elongation ; tape stretch
丝网延伸率 stencil tension
延伸性延伸率 extensibility
The ductility property is enhanced with no change of intensity.
同时提高了合金伸延伸率,而强度值基本不变。
参考来源 - 静电场对铝合金的作用效应与机制The lower the Tg is, the more flexible VAE latex is, and the less the plasticizer in JS coating, the better the elongation of film is.
VAE乳液的Tg越低,其柔韧性越好,JS防水涂料配方中所需的增塑剂含量越低,涂膜的延伸率越高。
参考来源 - 用于JS涂料的内增塑低T·2,447,543篇论文数据,部分数据来源于NoteExpress
结果表明,当跨越膝区时延伸率及相应的核作用参数发生变化。
The results show that there is change in the elongation rate and corresponding nuclear interaction parameters when span knee region.
对烧结样的相对密度、抗拉强度、延伸率等性能进行了测定与分析。
Relative density, tensile strength and elongation of samples were also measured and analyzed.
这就是说,设计人员通常只能利用那些公开发表的屈服强度、极限强度和延伸率等数据资料。
This means that the design will usually have only published values of yield strength, ultimate strength, and percentage elongation.
应用推荐