本文对饱和水蒸气和空气的混合物在垂直表面上滴状冷凝传热特性进行了实验研究。
Dropwise condensation heat transfer characteristics of saturated steam-air mixture were investigated experimentally on a vertical organic-film-coated plate.
在离水不到一毫米的地方,空气的温度接近于地表水的温度,空气中的水蒸气几乎饱和了。
Within about a millimeter of the water, air temperature is close to that of the surface water, and the air is nearly saturated with water vapor.
后冷却器出来的压缩空气在其出口温度下应该是水蒸气饱和的,且气流温度应该是压缩空气的压力凝露点。
After cooler out at the exit of compressed air temperature should be saturated steam, and air temperature should be pressure of compressed air condensation point.
水蒸气饱和的压缩空气流进入“在线”干燥塔。
Water vapor saturated compressed air flow into "online" dry tower.
当温度降低时,空气中的水蒸气饱和度降低,湿度减小。
When temperature is lower, water vapour in the air, humidity decrease.
斑晶(石英)中流体包裹体具有饱和及过饱和盐水蒸气沸腾流体包裹体组合的特征,缺乏熔融包裹体。
The fluid inclusions in the phenocrysts (quartz) show the features of the assemblage of saturated and oversaturated saline water vapor boiling fluid inclusions and are lacking in melt inclusions.
在模拟预测值的过程中,采用了饱和溶液中的水蒸气压差换算成水中温度的方法。
Method of vapor pressure in saturated salt solution converted into temperature in water was used in the predict value of simulating the nutrient release.
实验结果表明,用该工艺处理的甲苯废气可以达标排放,吸附饱和后的ACF用热的水蒸气再生效果良好,实验对工业实际应用具有一定的指导意义。
The experimental results show that the treated waste gas can be let off up to par. The result of using hot vapor to regenerating the saturated ACF is...
提出了一元多项式形式的水蒸气饱和压力与饱和温度关系的数学模型,进行了牛肉冻结过程的计算机模拟,在此基础上进行了牛肉冻结过程中干耗量的数值计算。
In this paper, the mathematical model of the reltion between water saturation vapor pressure and saturated temperature is established in the form of monoacidic polynomials.
如果温度一定,空气中的水蒸汽含量与不饱和状态下最大水蒸气含量就有相对关系。
The amount of water vapor in the air relative to how much water vapor the air can "hold" before saturation occurs at a given temperature.
然后综合考虑了水蒸气状态方程、表面张力计算方法和水的密度计算方法对计算临界液滴半径的影响,进而得出了计算过饱和状态下临界液滴半径的具体形式。
In addition, on the basis of available experimental data a formula for the exact prediction of liquid droplet surface tension was obtained by using a fitting process.
然后综合考虑了水蒸气状态方程、表面张力计算方法和水的密度计算方法对计算临界液滴半径的影响,进而得出了计算过饱和状态下临界液滴半径的具体形式。
In addition, on the basis of available experimental data a formula for the exact prediction of liquid droplet surface tension was obtained by using a fitting process.
应用推荐