由于反向代理是主要的接触点,因此可以执行ssl负载分散等工作;ssl负载分散要求服务器为客户机希望连接到的主机名对应的服务器。
Since it is the primary point of contact, the reverse proxy can perform such operations as SSL offload, which requires that the server be the hostname to which the client is expecting to connect.
类似地,操作连接器取得业务流程规则评估的结果,以有效负载的形式从内部JMS消息队列检索一个操作,并将其传递给接触点。
Similarly, action connectors take the results of business process rule evaluation, retrieve an action as a payload from the internal JMS message queue, and pass it to a touchpoint.
如果负载电阻被直接连接到伏特计的输入端子,通过继电器触点的电流会产生电压降,测得的电池电压将存在误差。
If the load resistor was connected directly across the voltmeter input terminals, the current through the relay contacts would cause a voltage drop and the measured cell voltage would be in error.
如果一个触点在初始变形时即屈服,负载去除后,它将不能回复到原来的形状。
If a contact has yielded during the initial deflection, it will not return to its original shape when the load is removed.
本实用新型在负载发生短路故障时能自动停止工作,同时能提高触点的使用寿命。
The utility model can automatically stop operation when a load has short circuit fault, and simultaneously, the service life of the contact can be raised.
大触点间隙型,可用于大功率马达负载;
The large contact interval type, can be used in the motor load of high-power ;
本文主要研究触点带低电平负载时,继电器的动态接触特性。
This paper focuses on the dynamic contact characteristic of relay in low-duty load performance.
即使对于电阻性负载,屏蔽电缆的电容也可能会导致继电器触点焊接。
Even with resistive loads, the capacitance of a shielded connecting cable may cause relay welding.
对于频繁通断的负载,应该选用晶闸管输出或晶体管输出,它们属于无触点元件。
For frequent load-off should be selected output or thyristor output transistors, which are non-contact component.
对于频繁通断的负载,应该选用晶闸管输出或晶体管输出,它们属于无触点元件。
For frequent load-off should be selected output or thyristor output transistors, which are non-contact component.
应用推荐