随气压的增加，放电的光信号脉冲数不断增加。
The number of light emission spikes of discharge increases with the gas pressure increasing.
提出了基于脉冲数互比的轮胎气压异常报警模式。
Last, this paper brings forward an alarm mode of tire pressure abnormity based on pulse intercomparison.
影响因素的大小依次为：电场强度、料液比、脉冲数。
The effect levels of these factors successively were electric field intensity, the ratio for material and liquid, and impulsion frequency.
可选的，X2的速度输出提供两倍的改善低速运行的每转脉冲数。
An optional, X2 speed output provides twice the number of pulses per revolution for improved low speed operation.
基于抛物线比例导引原理，详细分析了弹道修正所需求的脉冲数。
Based on the principle on parabolic and proportional navigation guidance (PAPNG), the required pulse number for trajectory correction was analyzed in detail.
更具体地，按照输入帧频率的函数来修改视频帧内的维持脉冲数。
More particularly, the number of sustain pulses within the video frame and selected by the power level mode is modified as a function of the input frame frequency.
研究结果表明，杀菌效果随磁感应强度的增强而增强，随脉冲数的增加而增强。
It was confirmed that the effect was improved with the rising of magnetic intensity and pulsed number.
通过在回采巷道内测试煤岩体的电磁辐射脉冲数，验证了采动影响下围岩应力演化。
The pulse numbers of electromagnetic radiation monitored in gateways verifies the mining stress evolution of surrounding rock.
集抄电能表是通过将原基表的铝盘转数转化成脉冲信号，并将脉冲数转化为电量数据存储。
The concentrated copy electric energy meter is to old meters aluminium disk revolution translate into pulse signal, and to pulse count translate into electric vector data for storage.
霉菌、酵母菌对脉冲磁场的耐性很大，需要很高的磁场强度和一定得脉冲数才能将其杀灭。
Molds and yeasts have strong resistance to the effect of pulsed magnetic field, which mean that higher magnetic field and more number of pulses would be used to kill them.
分析了周期性对称调制伪模式的显示周期与平面宽度和调制周期内的调制脉冲数之间的关系。
The display period of periodic pseudo-pattern in a virtual 2-D plane is dependent on the pulse number in a modulation period and the display plane width, which is proved in this paper in detail.
推导了被测线宽与光学性能参数，结构参数，振荡频率以及高频矩形脉冲数之间的函数关系式。
Functional relations between measured linewidth and optical parameters, structural parameters, oscillator coil and high-frequency rectangular pulse Numbers have been derived in the paper.
流量传感器将叶轮转动信号转换成电脉信号，计算机通过记录脉冲数实现对流过的高温水进行累计测量；
The flow sensor made the leaf wheel change the pulse signal, the computer use the pulse number to record the heat water quantity.
通过对捷达轿车的道路试验，研究了汽车行驶速度、载荷及轮胎气压对轮速传感器脉冲数相对差值的影响。
Through the road test on JETTA passenger car, research the effect of the vehicle velocity, load and tire pressure on the relative difference of pulse counts of wheel sensors.
采用“填脉冲”测温方法，根据周期内填入的脉冲数，计算温度信号的周期，再利用软件算法得出温度值；
Based on "filling pulse" method, the temperature value can be calculated according to the filled pulse number in the cycles.
硬件局部应用霍尔元件将自行车每转一圈的脉冲数送入单片机系统，然后单片机系统将旌旗灯号颠末处置送显现。
Hardware part USES hall element will bike every one round number of pulses into SCM system, then SCM system will signal processed send display.
签字的时间分析，包括时间米脉冲数发生在一个时间间隔，即触发随机事件后，一个检测，或在源裂变事件，触发。
The time analysis signatures include the number of time m pulses occurs in a time interval, that is triggered randomly, upon a detection event, or upon a source fission event triggered.
在使用计算机对外部脉冲进行计数的过程中，由于干扰脉冲的存在，计算机得到的脉冲数往往比实际的脉冲数要多。
When we use computer to count the number of external pulse, because of disturbing pulses the number of pulses that computer receives is bigger than its actual number.
采用霍尔传感器采集液压泵旋转产生的脉冲，结合单片机定时器的中断来精确计时，并对单位时间内的霍尔脉冲数进行统计。
Then, the interrupt of the single chip timer had been used to time precisely, and the Hall pulse number had been counted in unit time.
在自行设计的动态误差实验系统中，同步采集标准信号（电机脉冲数）和测量信号（光栅脉冲数），实时比对分离出动态误差。
In a self-designed dynamic error experimental system, the standard signal (motor pulses) and the measured signal (grating pulses) were collected synchronously, and isolated the dynamic error.
通过单片机的设置可使内部定时器T1对脉冲输入引脚T0进行控制，这样能精确地算出加到T0引脚的单位时间内检测到的脉冲数；
SCM through the setup will enable the internal timer T1 pulse input pin T0 control, This can be accurately calculated foisted T0 pin unit time detection of the pulse;
根据速度传感器的型号，每一个轮齿产生的脉冲数可以是2- 16，并通过实时处理的特征，确保这一脉冲从第一个轮齿开始旋转时就能感应到。
Depending on the sensor model the number of pulses resulting from each gear tooth may be 2 to 16, with the nature of the realtime processing ensuring that this occurs from the first tooth sensed.
主要介绍了旋转编码器的工作原理，通过8051单片机来累计旋转编码器被刮水器转轴带动所产生的脉冲数，将其换算转化为角度，从而达到测量刮水器转角的目的。
Making use of rotary encoder attains the purpose of measuring rotative Angle of wiper through single chip computer 8051 to count the pulse of rotary encoder generating, which is drove by wipers axle.
主要介绍了旋转编码器的工作原理，通过8051单片机来累计旋转编码器被刮水器转轴带动所产生的脉冲数，将其换算转化为角度，从而达到测量刮水器转角的目的。
Making use of rotary encoder attains the purpose of measuring rotative Angle of wiper through single chip computer 8051 to count the pulse of rotary encoder generating, which is drove by wipers axle.
应用推荐