同时，脉冲充电电压越高，凝固组织。
Meanwhile, the higher HDPEC discharge is beneficial to modification of solidification structure.
研制了一种用于铜蒸气激光器的高稳定度同步延迟脉冲充电开关电源。
A highly steady synchronous pulse charging power supply for Copper Vapor Laser was developed.
针对当前电动车的现状研究，试验了去极化脉冲充电结合并联充电的方法。
According to the current research of electric vehicles, a test was made on a new method of depolarized pulse charging and parallel charging combination.
交流阻抗谱结果显示在双向脉冲充电下，锂电极的表面积增长较直流充电时缓慢。
The results of the impedance measurement show that the surface area increases much slower in bipolar pulse current charge process than that in DC charge process.
变幅脉冲充电模式，减少充放电容量比率和失水量，促使串联中各电池性能的一致，达到延长深循环寿命的目的。
C variable amplitude pulse charging mode was proposed to reduce capacity ratio of charge-discharge and water-loss rate, so the batteries in series were in conformity, thus to extend the cycle life.
慢脉冲中的小电流有效地控制了离子浓差极化，提高了充电效率。
The small current of the slow pulse could efficiently decrease the ionic concentration polarization and increase the charging efficiency.
为满足脉冲电源重复频率运行时直流电源的稳压性问题，设计了晶闸管快速充电自停自补单元，同时也提高了整个电源系统的效率。
In the case of repetition mode of the pulse power supply, Fast charging circuit is designed to enhance the stabilize and charging efficiency of the DC power supply.
系统负荷投切和电容器充电的仿真结果表明，该方法能快速有效地区分暂态脉冲和振荡暂态。
The simulations of load switching and capacitor charging show that the proposed method can quickly and effectively class the impulse transient and oscillation transient disturbances.
本文对强流脉冲电子加速器的充电过程进行了分析，并推导出电压传输系数的解析表达式。
The detailed analysis of charging process in the pulsed intense-electron-beamaccelerator is presented. And the expression of voltage-transition coefficient isdeduced as well.
介绍了一种轻便恒流充电脉冲固体激光器电源。
The paper introduces a compact constant current charging power supply for pulse solid laser.
为激光焊机研制的恒流充电、高能量、长脉冲输出脉冲激光电源，运转数年，表明这种电源安全、可靠、省电、故障率低。
The Laser supply that is charged by constant electric current . has high energy and long pulse width was developed for laser welder. It has been used for several years.
研制出了额定充电电压可达1000v的大功率、高强度、高频率的脉冲磁场发生设备。
We developed the rated charging voltage being able to amount to 1000v big power, high strength, high frequencies of the pulse magnetic field equipment.
一种充电脉冲发生器，曝光发生装置，以及充电脉冲输出的方法。
A charging pulse generator, exposure generating device therefor, and charging pulse output method.
在脉冲电容器充电过程中，高压云母电容器承受高电压；
The divider consists of a pulsed resistor voltage divider and a high voltage mica capacitor.
介绍了IGBT谐振充电型脉冲激光器电源电路的实用测试方法。
The practical measuring method of IGBT resonant charging pulse laser power supply is introduced.
传输线电容量小而充电电压高时，传输线上的充电电压不稳定，影响输出脉冲电压的稳定。
The voltage charged on transmission line will be unstable when capacity of transmission line is very low and the charging voltage is high. It then influences the stability of the output pulse.
利用热脉冲技术研究了不同湿度下电晕充电的聚酰亚胺薄膜沉积电荷平均深度向背电极的迁移规律。
The rule of the shift of the mean charge depth at different environmental humidity was discussed for this electret material by heat pulse method.
但由于达到神经电位阈值所需的磁刺激脉冲能量较大，对电源功耗的要求限制了磁刺激的高频应用，本文研制了一种用于高频磁刺激仪的双向充电电路，用以降低功率消耗。
The objective of this paper is to present a novel design of the bidirectional charging circuit used in the high frequency magnetic stimulator to lower the electric power consumption.
相比较而言，恒流充电具有较高的充电效率，所以在高压强流脉冲放电技术当中一般都采用恒流充电方式。
Comparatively, the former has relatively higher charge efficiency, so it is frequently used in the technology of high voltage and large current discharge.
储能电容器的工作过程是在高压直流条件下进行较长时间充电，然后在很短的时间放电，从而在负载上形成高电压、大电流的脉冲。
As the storage capacitor charged under DC and discharges in a short time, which form a high voltage and large current pulse.
介绍了一种高频串联谐振充电的固体脉冲激光电源及其数字化控制恒流充电技术。
This paper introduces a high-frequency series resonant charing method of solid pulsed laser power source, basing on constant current charging of digital control technology.
通过几种充电模式充电时析气的对比实验证实慢脉冲快速充电方法是一种低析气量、高效率的快速充电模式。
By comparing the volume of gas evolution under several different charging models, it was verified that fast charge with slow pulse was a kind of low...
在快速充电方面，确定了一种电压控制的放电回馈型脉冲快速充电技术。
Fast charge in respect, determined a fast charging technology named voltage-controlled energy-feedback pulse charge.
在与全桥电压型充电方式激光电源比较的基础上，提出了一种谐振充电式脉冲激光电源。
On the basis of comparing with power supply of full bridge voltage mode, the authors bring forward the full bridge series resonant mode applied in the pulsatile laser power supply.
通过实验研究了充电介质、螺旋匝数及形成线结构与螺旋脉冲形成线特性参量间的数值关系。
The relations between dielectric, Numbers of circles and the characteristic parameters of the helical line were studied.
适用于电容器充电后瞬间放电的脉冲电路中。
Suitable for instantaneous discharge after electrifying capacitor for pluse circuits.
适用于电容器充电后瞬间放电的脉冲电路中。
Suitable for instantaneous discharge after electrifying capacitor for pluse circuits.
应用推荐