用x -射线能谱仪测定了界面相的化学成分。
The chemical composition of the interfacial phase was analyzed by EDAX.
探测效率是X射线光电子能谱仪一个很重要的仪器参数。
Detective efficiency is an important instrumental parameter of X ray photoelectron spectrometer.
采用金相、电镜、能谱仪等手段对盘管穿孔原因进行了分析。
The paper analyses the cause of boiler coil perforation by means of metallograph, electron microscope and energy spectrometer.
利用X -光电子能谱仪分析了改性处理后的表面化学性质。
The chemical properties on the surface of the GACs were determined by X-ray photoelectron spectroscopy (XPS).
用X射线光电子能谱仪(XPS)研究了仿制的铜红袖的着色机理。
The colour mechanism of imitated copper-red glaze was studied under the use of XPS.
伽玛能谱仪在校准检定过程中,仪器本底对检定结果有着重要的影响。
In the process of the calibration and verification of gamma-ray spectrometer. the background of the instrument is of important effect on the verification results.
报道了我们自行搭建的扫描探针电子能谱仪的数据获取系统的物理实现。
The physical frame of a home-made data acquisition system of the scanning probe electron energy spectrometer (SPEES) was reported.
利用场发射电镜、能谱仪等对接合区的界面和组织形貌进行了分析比较。
The microforms of diffusion joint were analyzed using field emission scanning electron microscope with an attached energy dispersive Xray analyzer.
用扫描电镜(SEM)和能谱仪对龙山黑陶的显微结构和化学组成进行研究。
The scanning electron microscope (SEM) and power spectrum are used to research the microstructure and the chemical composition of the black pottery.
报道了对扫描探针电子能谱仪(SPEES)中俄歇电子出射的理论模拟研究。
The simulation of the Auger electron emissions in scanning probe electron energy spectrometer (SPEES) is reported.
采用金相、扫描电镜及能谱仪等测试方法,对铝质易拉罐内侧表面进行了分析。
The methods of metallography, SEM and EDS were employed to analyze the inside surface of the "Bai Hua" pop top can made of aluminum.
再用PHI 550型俄歇电子能谱仪测出上述样品金膜中银的浓度剖面分布。
After that the above samples have been analysed by AES (type PHI 550) and silver concentration profiles in the gold films have been obtained.
并通过X射线能谱仪(EDS)分别测定了膜在氧化和还原状态下的元素组成。
The elementary composition of NiHCF films in reduced and oxidized form were also characterized by energy dispersive X-ray spectroscopy (EDS).
采用光学显微镜、扫描电子显微镜和电子能谱仪等方法对开裂齿轮进行了分析。
By means of optical-microscopy, scanning election microscopy (SEM), and election diffraction spectrometer (EDS) etc., the crack of gear was analyzed, the reason of the failure is found.
运用金相显微镜、描电镜和能谱仪,研究了前雾灯遮光罩表面处理后起泡的原因。
The causes of the front fog lamp shield blistering after surface treatment are studied by means of metalloscopy scanning electronic microscope and energy spectrum analysis.
通过欧杰电子能谱仪,发现水锈膜外层富含碳,在下层富含铁和氧,可能是氧化铁。
From Auger Electron Spectroscopy, it has been found that the outer layer of a rouge film is carbon rich, and the underlying region is iron and oxygen rich, probably iron oxide.
利用扫描电镜和能谱仪对不锈钢电极材料在高温动态铝液中腐蚀机理进行了实验研究。
The corrosive experiments on stainless steel electriode in dynamic aluminum melt are studied by scan electric mincroscope, composition analysis by electron probe.
利用金相显微镜、能谱仪等分析方法,分析研究了脱硫装置中钛制减压阀的腐蚀原因。
The reasons of the corrosion occurred in the titanium pressure-relief valve in the desulfurizing unit were studied by optical microscope and energy spectrometer.
实际建立的系统包括激光器、外光路系统、真空制样室、俄歇能谱仪、电子发射测量仪。
The total system comprise laser, external ray system, vacuum chamber, AES and emission electron surveyor.
用扫描电镜(SEM)、能谱仪、XPS对薄膜表征,用引拉法测定了薄膜的附着强度。
The characteristics of the films have been investigated by scanning electron microscopy(SEM), EDS, X-ray photoelectron spectroscopy(XPS), and the adhesion of films were tested by tension test.
本文应用XPS(X射线光电子能谱仪)研究了真空烘烤对碘化铯光阴极化学状态的影响。
The effects of vacuum-baking on the chemical state of CsI photocathodes are studied with X-ray photoelectron spectroscopy (XPS).
能谱仪上用的线性放大器,除了有足够的放大倍数外,还须有良好的线性和宽广的动态范围。
The linear amplifier on the spectrometer, besides it has the enough enlargement factor, and needs the good linearity and the broad dynamic range.
用扫描电子显微镜(sem)和X射线光电子能谱仪(XPS)对钢球磨损表面进行了分析。
The worn surfaces of the steel balls were analyzed by scanning electron microscopy (SEM) and X-ray photoelectron spectroscopy (XPS).
用扫描电子显微镜和能谱仪对钨和铜以及不锈钢的热等静压焊接试样的焊接界面进行了分析研究。
The SEM and EDS were used in this paper to analysis the welding interface of the specimens of tungsten and copper, copper and stainless steel made by HIP welding.
本文阐述了电子能谱仪的关键部件——电子能量分析器的一种慢性故障现象(沾污)及其消除方法。
This paper presents a method to eliminate the chronic deterioration on the performance of electron energy analyser, which is a key component of the electron spectrometer.
本文对数控车削纯镍时刀具的沟槽磨损问题,应用扫描电镜、电子探针、俄歇能谱仪等进行了探讨。
Using electronic sweep mirror, electronic prober and energy spectrum meter to investigate the groove shape wear of a cutting tool, while numerical controlled turning the pure nickle.
该文主要论述采用新一代的扫描电镜和带有图像分析功能的能谱仪联合对砂岩和砂岩铸体进行分析。
In this paper, a new generation of scanning election microscope (SEM) and an energy spectrometer (ES) with the function of image analysis are combined used to analyse sandstone and cast sandstone.
应用扫描电镜及X射线能谱仪等设备,对采用线切割制取的裂纹样品内表面的黑色不明物进行了分析。
The black abstract material which sticks to inside crack of the sample machined by wire-electrode cutting is analyzed and studied by using scanning electron microscope and X-ray energy spectrometer.
射线能谱仪分析结果表明界面间的元素扩散十分强烈,并由此促进了覆铝钢板与搪瓷层形成良好的密着。
The X-ray photoelectron spectroscopic analysis showed that there existed a strong elemental diffusion at interface which resulted in the strong adherence between the enamel and aluminum-coated steel.
利用场发射扫描电镜(FESEM)及其附带能谱仪研究了失效空心阴极发射体的表面形貌、元素组成。
Surface morphology and composition analysis of the failure emitter of hollow cathode were characterized by using FESEM and EDS.
应用推荐