粘弹性与胶凝温度、胶凝强度、屈服应力和触变性等参数有关。
Viscoelasticity is related to some properties such as gel point, gel strength, yield stress and thixotropy.
同一种季铵化程度TMC,随着TMC浓度的增加,胰岛素液体栓剂的胶凝温度减小,胶凝强度和生物黏附力均增大。
With the increase of TMC concentration, there was an decrease in gelation temperature, while an increase in both of gel strength and bioadhesive force.
这种胶凝材料可以满足较低强度通用硅酸盐水泥的要求。
The strength of this cementing material can meet the requirement of lower strength cement.
试验研究了石膏的掺量对高性能胶凝材料的需水量、凝结时间、强度、收缩性的影响,以此作为优化石膏掺量的依据。
The influence of gypsum content on water demand, time of setting, strength and shrinkage of high Performance cementitious material is tested as warrant for optimizing gypsum content.
研究了不同的煅烧温度及保温时间对脱硫石膏-粉煤灰新型复合胶凝体系抗压强度的影响。
The effect of different calcination temperature and the maintaining time at a certain temperature on the compressive strength of flue gas desulphurization gypsum-fly ash composite were studied.
试验结果表明:蒸汽养护条件提高了水泥-粉煤灰复合胶凝材料的早期水化速度,并且提高了硬化浆体抗压强度。
The experimental results indicate that steam curing condition increases early hydration velocity of cement-fly ash composite binders and improves compressive strength of hardened pastes.
可以将赤泥配制成无熟料的且具有一定强度的水硬性胶凝材料。
The fully activated red mud then can turn into a hydraulic binding material that is no clinker and has specified strength.
粉刷石膏中掺入适量的自制无机复合胶凝材料,可显著提高石膏的耐水性和强度。
The water-resistance and strength of stucco gypsum can be improved remarkablely by adding proper quantity self-made inorganic composite glue congeal materials.
钢渣与粉煤灰复合制成的胶凝材料比单独使用一种废渣的强度高,显示出明显的叠加效应。
The pressure strength of gelatinous material prepared by steel slag and fly-ash is higher than those of materials prepared by single waste slag, exhibiting obvious superimposing effect.
从抗压强度和安定性两方面测试了中温处理铁尾矿、钢渣及油页岩渣后物料的胶凝性能,利用XRD对中温处理后物料的物相组成进行了分析。
The cementing performance of such wastes as iron mine tailings, steel slag and oil shale residue was tested with XRD at middle temperature in the perspective of compressive strength and stability.
载体能参予多孔混凝土中的胶凝材料的水化过程,故该种多孔混凝土的强度和性能随着龄期增长而提高和改善。
The carrier can participate in the hydration of the binding material in the porous concrete, so the strength and behaviour of this kind of porous concrete are improved with the age.
以胶凝时间和凝胶强度为指标,通过单因素实验确定添加适当用量的琼脂、明胶、海藻酸钠和低甲氧基果胶可使酸乳胶凝。
Index on gel time and gel strength - the effect of single-factor test indicated that AGAR, gelatin, sodium alginate and low methoxyl pectin could gel yoghurt effectively.
降温速率越高,测量温度下蜡晶结构强度和胶凝温度越低。
The strength of waxy structure and gelation temperature decreased when increasing cooling rate.
用扫描电镜观察了硬化浆体的微观形貌,同时测定了各种组成的复合胶凝材料的净浆强度。
The morphology of hardened pastes was investigated using a scanning electron microscope. The strength of pastes was measured.
针对当前矿山膏体胶结充填成本高、强度低等现状,提出了以部分粉煤灰替代水泥作为胶凝剂。
In view of the high cost and low strength of the paste cement filling used at present in mines, it was proposed to use partial fly ash in stead of cement as the binding agent.
研究了矿渣的粉磨细度、激发剂的掺量、改性剂的种类与掺量对矿渣胶凝材料的干燥收缩性能及强度的影响。
The slag grinding fineness, additives of exciting agent, modifier kind and quantity, which influence the dry contractibility and strength of slag cementing material, have been studied.
实验中应用的混凝土的强度等级分别为C20和C60,其中粉煤灰的掺量(胶凝材料的质量分数)分别为未掺、10%、20%、30%、40%。
In the test, the strength grade of concrete is C20 and C60, and the cementitious system contains 10%, 20%, 30% and 40% of fly ash in accord with weight.
高性能胶凝材料主要用于高性能混凝土,具有强度高、需水量小、水化垫低和收缩小等特点。
High Performance cementitious material is specially used for high Performance concrete. Propetties of that are high strength, low water demand, low hydration heat and low shrinkage.
根据颗粒紧密堆积理论,探讨胶凝材料的颗粒级配对水泥凝胶体微观结构及强度的影响。
By using particle dense packing theory, the influence of particle size distribution of cementitious material on microstructure and strength of cement gel were discussed in this paper.
本文尝试采用粉煤灰取代部分混凝土中胶凝材料—水泥,比较了在不同水胶比下不同的粉煤灰掺量对混凝土强度、和易性的影响。
The attempt to replace part Fenmeihui Jiaoning materials-concrete, cement, plastic more than water under the various different powdery ash Chanliang of concrete strength, vulnerable nature.
但却会明显降低高强度等级混凝土所用胶凝材料的水化程度,使其绝热温升值下降。
However, the hydration degree of binder, as well as the adiabatic temperature rise for high strength concrete, will be obviously decreased due to the increase of initial casting temperature.
结果表明:C100高性能混凝土胶凝材料具有较高的强度;
The test results show that the C100 high-performance concrete has high intensity;
而且抗折强度还与胶凝材料的多少有关,随着胶凝材料的减少,抗折强度会缓慢增加。
And the flexural strength is linked with the quantity of cementitious materials. With the reducing of cementitious materials, the flexural strength could increasing slowly.
离子强度、蛋白种类及浓度均对硅溶胶-凝胶体系的胶凝时间和凝胶状态有影响。
The ionic strength, the type and the concentration of proteins can affect the gelation time and the state of the silica sol-gel system.
离子强度、蛋白种类及浓度均对硅溶胶-凝胶体系的胶凝时间和凝胶状态有影响。
The ionic strength, the type and the concentration of proteins can affect the gelation time and the state of the silica sol-gel system.
应用推荐