温度升高，聚合物溶液粘度下降。
普遍认为聚合物溶液可有效提高波及效率。
It's known to all that polymer solution can increase sweep efficiency.
本文论述了聚合物溶液超声降解的影响因素；
The effects of ultrasonic degradation of polymer in solution are reviewed in the paper.
在另一个方法中，在聚合物溶液中进行氟化。
In other approaches, the fluorination is performed in a polymer solution.
聚合物溶液表现出较好的耐盐、耐温及耐酸性能。
Polymer solution have some good properties to resist salt, temperature and acid.
提出用形变恢复能力来表征聚合物溶液弹性的大小。
The recovery after deformation was proposed to characterize the elastic property of polymer solution.
聚合物溶液的有效粘度由剪切粘度和弹性粘度组成。
The effective viscosity of polymer solution consists of shear viscosity and elastic viscosity.
最常见的淬火介质有水溶液、聚合物溶液和矿物油。
The most common quenchants are water aqueous, polymer solutions and mineral oil.
结果表明，用聚合物驱产出水配制聚合物溶液是可行的。
The results show that it is feasible to make up solution with produced water of polymer flooding.
研究了粘弹性聚合物溶液在盲端孔隙模型中的流动与驱替特性。
The flow and displacement characteristics of the viscoelastic polymer solution in the pore model with blind ends are studied.
室内试验测试表明，大庆油田应用的聚合物溶液服从幂律模式。
Polymer solution rheology experiment showed that the rheology of polymer solution used in Daqing Oilfield obeyed power law pattern.
实验结果表明，水中的声传播速度大于聚合物溶液中的声传播速度。
It is shown that acoustic velocity of tap water is faster than that of the polymer solution.
用这两种聚合物溶液在不同的浓度和注入速度条件下进行了驱油实验。
The oil displacement experiments with two types of polymers were carried out under the conditions of various concentrations and injecting speeds.
分析了具有不同黏弹性质的聚合物溶液在油藏多孔介质中的流动规律。
The flow laws of the polymer solutions of different viscoelastic properties in porous reservoir media are obtained.
实验分析了聚合物溶液自身电阻率特征及聚驱前后岩石电性特征的变化。
The experiment analyzes electric character of the polymer solution and variety of the rock electric character before and after polymer flooding.
聚合物溶液在模型高渗透层内提高驱油效率作用的效果要好于中、低渗透层。
The effect of polymer solution on improvement of oil-displacement efficiency in high permeability layer is better than the effects in medium and low permeability layer.
为保证聚驱效果，聚合物驱油过程中一般采用低矿化度清水配制聚合物溶液。
To ensure the effect of polymer flooding, polymer flooding process generally use low salinity water for preparation of polymer solution.
聚合物溶液沿高渗透层突进，是影响大庆油田聚合物驱效果的一个主要因素。
The hurtlement of polymer solution along high permeable zones in reservoir strata is an important factor affecting the oil displacement efficiency in polymer flood in Daqing.
本文针对油田污水配聚问题，探讨了阴阳离子及矿化度对聚合物溶液黏度的影响；
According to preparing polymer solution by oilfield produced water, the effect of ions and salinity on polymer solution viscosity was explored and discussed.
通过试验证明，低矿化度清水脱氧与否对聚合物溶液粘度及驱油效果没有明显影响。
The tests show that there is no clear effect to the viscosity of polymer solution whether the water deoxidizes or not.
室内聚合物的溶液流变性测试表明，大庆油田应用的聚合物溶液的流变性符合幂律模式。
Laboratory testing showed that rheological property of polymer solution used in Daqing Oilfield agree with power-law mode.
在聚合物驱油过程中，聚合物溶液的粘度和粘弹性对提高驱油效率起到了至关重要的作用。
In the process of displacement of oil by polymer solution, the viscosity and viscoelasticity of polymer solution are vital to displacement efficiency.
相对孔隙系数值可用以表征聚合物溶液流经孔隙介质时聚合物分子尺寸与滞留作用的关系。
Relative porosity factor value can be used to characterize the relation between the molecular size of the polymer and the its retention in the flow of polymer solution through porous media.
通过改变聚合物溶液浓度和岩心渗透率，计算了较宽浓度范围和渗透率范围内的衰竭层效应。
The depleted effects in a wider range of concentration and permeability of polymer solution were calculated with variations of polymer concentration and core permeability.
本文论述了聚合物溶液超声降解的影响因素；对超声波降解机理及超声降解动力学进行了讨论。
The effects of ultrasonic degradation of polymer in solution are reviewed in the paper. The mechanism and the kinetics of ultrasonic degradation of polymer in solution are introduced.
电纺丝是一种使带电荷的聚合物溶液或熔体在静电场中射流来制备聚合物超细纤维的加工方法。
Electrospinning is a novel processing technique for the production of ultrafine polymer fibers with electrically charged liquid jets of polymer solutions or melts in electrical static fields.
介绍了油田模拟井试验装置中聚合物溶液配比回路仪表的选型及其自动配比控制系统方案的设计。
Instrument selection and control system design for polymer aqua allocation system of oilfield well simulator is discussed.
研究表明，随着聚合物溶液浓度的增加，AS溶液在TATB表面的浸润性变差，浸润速度减小。
The results show that the wetting capability and the wetting speed of as solution on TATB explosive decreases with increasing of the concentration of as solution.
本文从阻力系数与孔隙系数角度出发，研讨了聚合物溶液在砂岩孔隙介质中降低流体流动度的机理。
This paper deals with mechanism of the decrease of the mobility of a polymer solution when it flows through a porous medium by means of resistance factor and porosity factor.
随着聚合物溶液浓度的增加，其声传播速度减小，其密度值也逐渐减小，但其表观粘度值逐渐增大。
With the concentration of the polymer solution increasing, acoustic velocity of the polymer solution decreases, and the polymer density decreases too, but the apparent viscosity increases.
应用推荐