内置的缓冲放大器陶瓷接收机开车。
设计了一种主要用于微传感器读出电路的输出缓冲放大器。
An output buffer amplifier with compact structure used in detection circuit of micro sensor is presented.
设计了一种用于LCD驱动的低功耗CMOS缓冲放大器。
A low power CMOS buffer amplifier for LCD driver is presented in this paper.
的HA- 5002是一款单片，宽带，高转换率，高输出电流，缓冲放大器。
The HA-5002 is a monolithic, wideband, high slew rate, high output current, buffer amplifier.
片内可编程基准电压源和基准电压缓冲放大器经过配置，可获得最高的精度和灵活性。
The on-chip programmable reference and reference buffer amplifier are configured for maximum accuracy and flexibility.
提出用高精度低漂移集成运算放大器OP-07组成同相放大器，作为监测电路的缓冲放大器；
It proposes using a noninverting amplifier consisting of a high accuracy and low drift integrated operational amplifier OP. 07 as a buffer amplifier in the circuit.
如图2 - 9所示，由于保护缓冲放大器具有典型值为104到106的开环增益，所以能够大大减少CSHUNT的充电时间。
As shown in Figure 2-9, the guard buffer significantly reduces the charging time of CSHUNT because of the open-loop gain (AGUARD), which is typically 104 to 106.
如图2 - 9所示，由于保护缓冲放大器具有典型值为104到106的开环增益，所以能够大大减少CSHUNT的充电时间。
As shown in Figure 2-9, the guard buffer significantly reduces the charging time of CSHUNT because of the open-loop gain (AGUARD), which is typically 104 to 106.
应用推荐