分析假设球内空气的行为符合压缩、粘性流体流动模型。
The air outside the ball was ignored, and it was assumed that the air inside the ball behaved according to a compressive, viscous fluid-flow model.
复合固体推进剂药浆是固体粒子含量很高的粘性流体。
Composite solid propellant slurry is a viscous fluid with high percentage of solid particles.
在处理粘性流体方面挠性叶轮泵有很多优于离心泵的地方。
Viscous fluid in dealing with aspects of flexible impeller centrifugal pump is better than many places.
纯粘性流体中与时间有关的一类包括触变性流体和流凝性流体。
The time-dependent group of purely viscous fluids includes the thixotropic and the rheopectic fluids.
挠性叶轮泵输送粘性流体的关键之处在于流速和水泵转速成正比。
Flexible impeller pump viscous fluid conveying the key lies in direct proportion to flow rate and pump speed.
应用粘性流体动力学基本方程，分析了聚合物物料在螺槽中的流动。
The flow of rubber compound in the screw channel was analyzed with the basic equation of the viscous fluid kinetics.
本文提出了一种数值求解不可压粘性流体定常运动的格林函数方法。
This paper presents a Green's 'function method for the numerical solution of steady-state incompressible viscous fluid flow.
本文由粘性流体动力学方程组导出溶潭内涡旋、速度及温度的分布。
The distribution of vorticity, velocity and temperature of the melt puddle were obtained by the viscous hydrodynamic equations.
通常将呈颗粒状的粘着剂与水混合后加热成糊状，最终制成粘性流体。
The adhesive, usually in granular form, is mixed with water and heated to form a paste which ultimately becomes a viscous fluid.
本文考虑了竖直毛细管中具有两个自由面的有限长液柱的粘性流体运动。
This paper deals with the motion of viscous liquid column with finite length and two free surfaces in a vertical straight capillary tube.
本文运用粘性流体有限元方法，计算软岩体中巷道围岩的速度场和应力场。
In this paper, a finite element method for viscous fluid is used to calculate the velocity and stress fields in the surrounding soft rock of a tunnel.
列举粗糙平面上的球，粘性介质中的刚体以及带充粘性流体腔的刚体为例。
Chaplygin's sphere on a rough plane and a rigid body in viscous medium or with a cavity filled with viscous fluid are discussed as examples.
本文提出一种非密接界面模型，其中两个弹性固体被一个粘性流体薄膜所分开。
One of the uncoupled boundary models has been suggested, in which two elastic solids are separated by a viscous fluid membrane.
提出了处理粘性流体晃荡与弹性结构相互耦合作用的理论及相应数值计算方法。
A theory and a corresponding numerical technique to deal with the coupled interactions between the liquid sloshing and the elastic structures are presented.
本文是国家教委博士点基金项目“粘性流体在叶片泵内的流动机理研究”的一部分。
The dissertation is part of the Doctoral Scientific Fund Project of the State Education Committee of China.
该阀适用于高粘性流体、悬浮状颗粒、纤维介质和有毒介质、腐蚀性介质的调节场合。
The valve is suitable for high viscosity fluids, like suspended particles, fiber media and toxic media, corrosive mediators occasions.
研究了粘性流体在三通道气流式喷嘴的雾化过程，考察了三通道喷嘴雾化性能的影响因素。
Atomization process of viscous fluid by using airblast three-channel nozzle and effects of different factors on this process was investigated based on the experiment.
本文应用粘性流体力学的方法推导了在钢不钻漏情况下移动式结晶器浇铸通道配合间隙公式。
The formula for moving mould casting passage assemble gap in the case of no steel leaking has been deduced by the viscosity fluid mechanics method.
最近粘性流体分布混合和动力系统的混沌行为联系起来，为分析和理解各种混合提供了新思路。
Recently, mixing of liquids has been associated with the chaotic behavior of dynamics system and it is to provide a new method for analyzing and understanding numerous mixing.
用粘性流体力学基本方程进行了模拟计算，计算部分着重分析物料特性参数及螺杆主要几何参数。
According to viscous fluid mechanics equation, simulating calculations that focus on properties of composites and geometry of screw were developed.
离心泵输送粘度大于水的石油产品或其它流体时，一般用输送水时的性能参数换算确定泵输送粘性流体时的性能。
When oil products or other fluids with viscosity larger than that of water, the pump's performance is usually conversed and determined by its performance parameters in pumping water.
本文提出了基于微分-积分方程组求解n - S方程的有限差分法求解不可压缩实际粘性流体绕孤立翼型流动。
A finite difference method based on differential-integral equation is presented for the solution of Navier-Stokes equations for incompressible viscous flow.
浮体在粘性流体中的侧倾振荡为阻尼运动，其侧倾角度随时间的增加而减小，在小角度时侧倾振荡与理论解接近。
The list vibration of the floating body well agrees with the one from the theory in the case of small Angle.
针对典型形状微通道(微缝隙)在滑移边界条件下，利用粘性流体运动方程和动量方程，推导出速度场和流动阻力。
Aimed at typical shape micro-channel (fissure) under slip confine condition, it used dauby fluid motion equation and momentum equation, derived pace bout and running resistance.
对聚合物电磁动态塑化挤出机螺杆轴向振动系统，根据牛顿型粘性流体的剪切理论，确定了聚合物熔体的阻尼系统。
Based on the shear theory of Newtonian viscous liquid, the fusible damp coefficient is established for electromagnetism dynamic polymer Extruder screw's axial vibration system.
本文的研究结果使粘性流体力学中的N—S方程又增添一例准确解，对工程实践中的具体问题有实用价值和指导意义。
Velocity sections are shown by electric computer. The studying in this paper not only make N—S function add a exact solution but also have practical value for engineering problem.
分析了冲击载荷作用下粘性流体阻尼器的工作原理，推导了阻尼力公式的表达式，运用落锤冲击试验确定了其中的参数。
The work principle of the viscous fluid damper under shock load is analyzed and the damping expression is derived, the parameters of which are determined using shock tests.
分析了冲击载荷作用下粘性流体阻尼器的工作原理，推导了阻尼力公式的表达式，运用落锤冲击试验确定了其中的参数。
The work principle of the viscous fluid damper under shock load is analyzed and the damping expression is derived, the parameters of which are determined using shock tests.
应用推荐