因此弯矩在形心处要引起正应力,从而引出所谓“等效轴力”的概念。
Therefore, the bending moment may cause normal stress at the axis of gravity, and the concept of "equivalent axial force" is induced.
核心配筋率、等效轴压比和配箍特征值是影响RRC柱抗震性能的主要因素。
The main factors that influence the seismic behavior of RRC columns are the percentage of central reinforcement, equivalent ratio of axial compression and characteristic value of stirrups.
由于曲率的影响,曲线梁在其曲率平面内弯曲时的中性轴不通过横截面的形心。因此弯矩在形心处要引起正应力,从而引出所谓“等效轴力”的概念。
When a curved beam is bending in the plane of the curvature, the neutral axis of cross section is not identical with the axis of gravity due to the influence of the initial curvature.
本文对影响柱延性的主要因素以及改善变形能力的措施进行了阐述,提出两种旨在提高柱承载能力的配筋方式,引入等效轴压比的概念代替传统的轴压比。
The main factors affecting the ductility of columns are reviewed, and two methods are proposed for improving the bearing capacity and ductility of the traditional RC columns.
在网络中使用理想变压器元件等效双轴电介质与各向同性介质分界面处的场匹配条件。
The ideal transformers in a network equate mode match condition of the interface between the isotropic and biaxial medium.
在理解飞机飞行品质规范MIL-STD- 1797A基础上,采用等效系统准则评价了某机的俯仰轴飞行品质。
The handing qualities of aircraft for pitch axis are assessed using equivalent system criteria based on the flying qualities specifications(MIL STD 1797A).
针对B0+B0-B0+B0轴式八轴机车不同的牵引方案,在定义了名义牵引高、过渡牵引高和等效牵引高的基础上,进行了轴重转移的计算分析。
The load transfer of B0+B0-B0+B0 locomotive with different traction schemes was calculated, basing on the definition of nominal and transitional and equivalent traction height.
本文采用等效锥形的方法研究了一种类锥形发散梯度折射率纤维的近轴成象,这种方法计算方便,且有一定的适用性。
The image of a taper-like defocusing GIRN fiber lens is studied by the method of "equivalent taper. " This method is easy to be used to calculate the gaussian parameters, and of some applicability.
根据不同荷载与路面状况下弯沉的实测结果,计算并分析了按弯沉等效的轴载换算指数的变化规律。
The change rules of axle exchange index based on deflection equivalent are analyzed according to the survey results in the different loads and pavement conditions.
本文引入了几何非线性关系和等效线弹簧模型对含裂纹的弹性轴弹性盘转子系统进行非线性动力学分析。
Non-linear dynamics characters of a rotor system for an elastic shaft-disk with a crack are examined by introducing the geometric non-linearity and equivalent line-spring model.
采用了等效单轴应力应变混凝土本构模式。
An orthotropic equivalent uniaxial stress-strain constitutive model of concrete is used.
发现体积含量为f的短纤维无序取向SFRC一维力学行为,等效于体积含量为F的短纤维单轴取向SFRC在取向轴上的力学行为。
One dimensional mechanical behavior of isotropic SFRC with fiber volume fraction fis equal to axial mechanical behavior of unidirec-tionally aligned short fiber composite with fiber volume fraction F.
采用刚塑性有限元法研究了多轴压缩过程中的坯料变形行为、等效应变大小、分布以及损伤值。
The billet deformation behavior, the magnitude and distribution of effective strain and damage value were investigated by rigid-plastic finite element method during multi-axial compressions.
将鹤管等效为储罐对称轴上的接地导体,推导了静电场边值问题的解析解。
Assimilating the filling pipe to a grounded conductor at the axis of the vessel, the electrostatic boundary problem is solved analytically.
以满足刚度等效为条件,求得一个能方便算出多种截面的可供选用的传动轴计算公式。
Based on the condition that the strength equivalent to the stiffness required to met, one equation to calculate the power convey shaft with several different section areas was derived in this article.
利用等效线弹簧模型近似计算了含裂纹转动轴的自由振动基频。
In this paper a model of the equivalent linear spring is proposed for approximately calculating fundamental frequencies of a vibrating shaft with an arbitrary crack.
将神经网络、遗传算法、三轴实验和离散元数值模拟相结合,用于改性砂土等效离散元接触模型参数反演。
The inversion method combining the genetic neural network and the discrete element simulation of triaxial tests is proposed for determining the contact model parameters of the conditioned soil.
将神经网络、遗传算法、三轴实验和离散元数值模拟相结合,用于改性砂土等效离散元接触模型参数反演。
The inversion method combining the genetic neural network and the discrete element simulation of triaxial tests is proposed for determining the contact model parameters of the conditioned soil.
应用推荐