因为优先级是用整数表示的，所以规范的实现可以提供更多的优先级别。
Since the priority is represented as an integer an implementation could provide many more.
用对数表示，这一信号强度相当于外太空的普通声音的30倍。
"U," in a logarithmic way, means about 30 times louder than the ordinary noise of deep space.
此图通常是用RDF三倍数表示的。
如您所见，可以用一个二进制数表示一个规则，可以用一个整数表示ca细胞在给定步数时的状态。
A binary number, as you've seen, can be used to represent a rule, and an integer can be used to represent the state of a ca cell at a given step.
updated：虚拟系统最后一次更新的时间，用自1970年1月1日午夜起的毫秒数表示。
Updated: Time the virtual system was last updated, represented as the number of milliseconds since midnight, January 1, 1970 UTC.
VxWorks的互斥锁在创建的时候，可以用一个布尔参数表示是否要优先级继承。
When created, a VxWorks mutex object accepts a Boolean parameter that indicates whether priority inheritance should be performed by the mutex.
FlockDB将图存储为一个边的集合，每条边用两个代表顶点的64位整数表示。
It stores graphs as sets of edges between nodes identified by 64-bit integers.
created：虚拟系统的创建时间，用自1970年1月1日午夜起的毫秒数表示。
Created: Creation time of the virtual system, represented as the number of milliseconds since midnight, January 1, 1970 UTC.
化学势，从基本方程上说，就是A对N的偏导，因此对A取N偏导，因此化学势也能，用正则配分函数表示。
The chemical potential from the fundamental equation up here is the derivative of a with respect to the number of particles.
但是在DB 2中，TIME用一个24小时格式的时钟数表示的，范围是从00：00：00到24：00：00。
But in DB2, TIME is represented as a 24-hour clock, which ranges from 00:00:00 to 24:00:00.
用一年左右和二年左右试验数据确定的徐变特性参数表示的徐变曲线与试验曲线相比较，结果表明它们之间相差很小。
It is shown that creep curve determined by creep parameters, obtained by test data in one year or two years, is totally in agreement with the test curve.
用华氏度数表示的绝对温标。
水泥浆产率一般用每袋水泥的水泥浆立方英尺数表示。
The slurry yield is typically expressed in cubic feet of slurry per sack of cement.
用该方法，可将作用在梁上的各种载荷用一个载荷集度函数表示。
Through this method, various kinds of complicated loads on the beam can be expressed by one load concentration function.
用波数-频率谱传递函数表征包括弹性板和流体负荷在内的整个系统的特性，导出了噪声场互谱函数的一般表示式。
Using the wavenumber frequency transfer function to describe the whole system consisting of the plate and the liquid loading, a general expression of the cross spectrum was derived.
提出了一种通用的定量计算方法，即用规范化指数表示各地区的资源丰度，用“度”作为资源丰度的计量单位。
The enrichment of area resources was expressed by means of a standardized index, and the degree was taken as quantitative unit of the enrichment of resources.
用灰数表示决策信息是合理的。
Using grey number to express decision information is reasonable.
推导用斯托克斯参数表示的光纤应力计算公式。
A formula is derived for calculating fiber stress showing by stokes parameter.
对各种费用的分析用算术均数表示。
径向束缚态波函数用合流超几何函数表示，束缚态的能量方程可由径向波函数满足的边界条件得到。
The radial bound state solutions are expressed in terms of the confluent hypergeometric functions and the energy equation is derived from the boundary condition satisfied by the radial wavefunctions.
有限元模型用质量和刚度参数表示，这些参数由正交条件和特征方程的加权欧氏范数取极小值来确定。
The finite element model is expressed by mass and stiffness parameters, which are determined by minimization of weighted Euclidean, norms of orthogonality conditions and characteristics equations.
给出了用四元数表示的刚体姿态调节问题的两种控制规律。
Two control laws are presented for attitude regulation of a rigid body expressed by unit quaternion.
用该位移势函数表示的应变及应力分量，其解答简捷适用。
A simple and useful representation of the stress and strain components are obtained by displacement function.
用复传递函数表示音响系统的特性除振幅响应外还有相位响应。
The characteristics of audio system represented by a complex transfer function include not only amplitude response but also phase response.
本文采用状态平衡方程推导出用超越函数表示的空间索单元切线刚度矩阵的精确表达式。
The precise tangent stiffness matrix of space cable element is derived in this paper by using equilibrium equation.
用光程函数和费马原理研究光栅的成像，用刻槽分布函数表示光栅的刻槽曲率及间距变化。
The groove pattern function was employed to express the curvature and groove space of aberration reducing gratings, and the dispersive system containing a single grating was discussed.
从理论上给出了微观系统在有限温度下态密度用松原函数表示的表达式。
A state density representative of microscopic system related to Matsubara function is theoretically given under finite temperature.
本文通过有限元法求解用流函数表示的拉普拉斯方程，进而计算轴流式机组的静态轴向水推力。
In this thesis, the Finite Element Method is applied to the solution of the Laplace equation formulated by means of stream function for the calculation of the static hydraulic thrust.
海图的基准比例尺是图上一个单位长度与其对应的球面上长度的之比，用分数表示。
The natural scale of a chart is the ratio of a length measured on the chart to a corresponding length measured on the surface of the Earth and is expressed as a fraction.
海图的基准比例尺是图上一个单位长度与其对应的球面上长度的之比，用分数表示。
The natural scale of a chart is the ratio of a length measured on the chart to a corresponding length measured on the surface of the Earth and is expressed as a fraction.
应用推荐