新制的饮料对温度要求严格控制在35摄氏度。
Refreshing drinks are in high demand as the temperature is 35 degrees Celsius.
杀菌恒温时间和温度要求。
按目标温度要求，进行补偿措施，有效地控制钢水温度。
According to requirement of aim temperature to implement compensated measures can effectively control the molten steel temperature.
因此，为了考虑在线脱气脱气装置的液体温度要求的影响。
Therefore, in order to consider the online degassing degassing device effect of liquid temperature requirements.
对于有温度要求的工业用水过程，提出了两阶段法的分解设计策略。
For the process of water utilization in industry with the requirement of certain temperatures, a two-stage decomposed design approach is proposed.
产品温度曲线是否降落到基于工程的玻璃转换温度要求的工程标准？
Does the product temperature Profile fall within the Engineering based specification for glass transition temperature requirements?
采用单片机和模糊控制实现对注塑机的料桶温度控制，以达到精密注塑的温度要求。
In order to obtain precise temperature adjustment and satisfy the requirement of plastic injection, a single chip with fuzzy control to realize an advanced temperature controlling.
可广泛用于对湿温度要求较高的工厂、生产车间及要求恒温、恒湿和易燃易爆场合等。
It can be widely used in the factory and workshop with strict and constant temp. and moisture demand, and the inflammable and explosive field.
HMA的拌和与施工温度要求很高，在生产过程中需要将沥青和集料加热到很高的温度。
For HMA's requirement of high temperature, asphalt and aggregate need to be heated to high level in the process of construction.
锅炉运行中，过热蒸汽温度要求维持在允许的范围之内，尤其要求严格控制超温现象的发生。
During boiler operation superheated steam temperature must be kept in allowable IIrange and the temperature excursion must be rigidly controlled.
目前对沥青混凝土路面坑槽、裂缝等病害的修补多采用热拌沥青混合料的形式，温度要求较高。
Currently the asphalt concrete pavement pit slots and crack are patched by heating asphalt mixtures mostly and needs higher temperature.
锅炉给水除氧系统存在溶解氧超标问题，原因是进除氧器的水温不能满足除氧的温度要求，除氧器的塔内损坏。
Boiler feed water dissolved oxygen oxygen system has exceeded the problem because the water temperature into the deaerator temperature can not meet the oxygen requirements of deaerator tower damage.
在蒸汽管道，伴热管线、小型加热设备，采暖设备，温度要求不高的用汽设备，应该选用热静力型疏水阀。3。在高温高压过热蒸汽管线和设备上，应该选用过热蒸汽专用疏水阀。
In steam pipes, coupled heat pipelines, small heating equipment, heating equipment, air temperatures do not ask for the use of equipment, it should be the choice of hot static type steam traps. 3.
能读出温度计上的温度是基本要求。
利用此类蒸汽可能代价不菲，因为这不仅要消耗额外的建筑材料，而且要求所用的建材更为牢固以经受更高的压力和温度。
Tapping this steam would be expensive, since it would require not only extra building materials, but also more durable ones, to cope with the higher pressures and temperatures.
F1赛车的车胎对环境温度有要求，当温度低于底限时候轮胎就会失去抓地力，这会大大减慢圈速。
F1 tyres have an optimum operating temperature, and when they drop below that they rapidly lose grip, which dramatically slows lap times.
研究人员首先要求被试者就谁能承受的温度可以长时间的恒定在那个温度，以及在不同的温度下他的痛感变化等问题做好记录。
The researchers first asked the participants to hold a block whose temperature could be controlled and report how much pain they felt at different temperatures.
他说，新的ACT治疗需要一剂以上的药物并且对温度很敏感，因此造成了遵守治疗要求和保管方面的困难。
The new ACT treatment requires more than one dose and is temperature sensitive, posing compliance and logistical difficulties, she says.
间歇式冻干设备便于控制物料干燥时不同阶段的加热温度和真空度的要求。
Intermittent freeze drying equipment for control of drying at different stages of heating temperature and vacuum degree requirements.
介绍了加热炉在使用转炉煤气作为燃料时，对其流量、压力、加热温度和纯洁度的要求。
The requirement to flow, pressure, heating temperature and purity of converter gas used in reheating furnace were introduced.
作为小温度范围准确度要求（几度），设备的整体测量链条的准确性是非常重要的。
As a small temperature rangeis required for accuracy (A few degrees) the accuracy of the equipment is veryimportant for the overall measuring chain.
随后要求被试估计房间的温度。分配到回忆被拒绝的被试的估计约为71华氏度(约为22摄氏度)——这比第二组被试的估计低5度。
When asked to estimate the temperature of the room, people assigned to ruminate about rejection said 71 degrees - about 5 degrees lower than temperatures given by the second group.
干燥机摆置是否适当，环境温度是否满足使用要求。
White dryer placement is appropriate, whether the environment temperature to meet the use requirements.
一旦牛奶达到要求的温度，就加入小牛的胃膜和一种发酵培养菌，同时停止搅拌。
Once it has reached the required temperature, rennet - taken from the stomach lining of calves - and a fermentation culture is added and the stirring stops.
玻璃传送厚度可根据有关加工玻璃工艺要求调节，加热温度可按需要事先设定。
Send thickness of the glass can be processed in accordance with the relevant requirements of glass conditioning, heating temperature may need to set in advance.
因而钻石化学蒸发沉淀的应用受到材料限制，要求材料在此温度下不软化例如硬质合金。
Thus, the application of diamond CVD is limited to materials which will not soften at this temperature such as cemented carbides.
要求温度在50和70华氏度，使地下室或半温暖的室内空间。
Requires temperatures between 50 and 70 degrees Fahrenheit so a basement or semi-heated indoor space is required.
要求温度在50和70华氏度，使地下室或半温暖的室内空间。
Requires temperatures between 50 and 70 degrees Fahrenheit so a basement or semi-heated indoor space is required.
应用推荐