我们迫使测试电流流过测试引线和被测电阻（R）。
The test current is forced through the test leads and the resistance (R) being measured.
然后仪表通过同一套测试引线来测量电阻两端的电压，并计算出相应的电阻数值。
The meter then measures the voltage across the resistance through the same set of test leads and computes the resistance value accordingly.
完成CATIV测试信息，9v电池，K型探头，眼袋情况，以及专业测试引线。
Complete with CAT IV test leads, 9v battery, Type K probe, pouch case, and Professional test lead Set.
对测试引线和DUT进行屏蔽(图3 - 6)常常能够将这种干扰的影响降低到可以接受的水平。
Shielding the test leads and the DUT (Figure 3-6) will often reduce interference effects to an acceptable level.
在使用较大的电流时，这一点特别重要。因为和接点两端的电压降相比，测试引线两端的电压降可能会比较大。
This is especially important when higher currents are used because the voltage drop across the test leads may be large compared to the voltage drop across the contact.
对引线键合定位平台进行了相关实验，对平台进行了性能测试。
A correlative performance experimental of wire bonding positioning table is tested.
因此测试区域应包括变压器中性点和避雷器接地引线以及易腐蚀区域。
So the measured region should include the ground leads of transformer and arrester.
在芯片测试中，若引线焊盘上的铝层被探针扎穿，就会影响引线键合的牢固性和器件的可靠性。
If the Al film on the bond pad is pierced through by the probe in wafer probing, the wire bonding strength and device reliability would be affected.
论述了电容型电流互感器不拆高压引线预防性试验的原理和方法，并介绍了现场实际测试结果，证明该方法是准确、高效，切实可行的。
The preventative test method is introduced for capacitive current transformer with high voltage lines in place that is proved to be practicable, high efficient and accurate.
两线测量方法用于低阻测试时的主要问题是测量结果中增加了引线的总电阻(RLEAD)。
The main problem with the two-wire method as applied to low resistance measurements is that the total lead resistance (RLEAD) is added to the measurement.
两线测量方法用于低阻测试时的主要问题是测量结果中增加了引线的总电阻(RLEAD)。
The main problem with the two-wire method as applied to low resistance measurements is that the total lead resistance (RLEAD) is added to the measurement.
应用推荐