减小污泥颗粒、增大污泥表面积更有利于污泥干燥过程。
Reducing the sludge particle size and increasing the surface area of sludge is more beneficial for sludge drying process.
本实用新型公开了一种转鼓式压膜污泥干燥机,属于环保设备技术领域。
The utility model discloses a rotary drum type squeeze-film sludge drying machine, which belongs to the technical field of environment-friendly equipment.
污泥干燥的外部条件对最终干燥效果影响不大,但对干燥时间影响较大。
The external condition of drying sludge has little effect on final moisture content, but it has greater effect on drying time.
对污泥干燥机进行质量、热量平衡计算,指出采用干化技术处理污泥的优点。对焚烧系统应注意的几个问题进行了论述。
This paper calculates the heat and mass balance of sludge dryer, points out the advantages in using dryer to treat the sludge, and discusses several key points of the incineration system.
本文是在污泥干燥特性研究的基础上指导转筒干燥过程,通过结合污泥干燥参数对转筒干燥过程编程模拟,优化转筒干燥。
This article is a study on the sludge drying characteristics to guide drum drying and through a combination of sludge drying parameters on drum drying process simulation to optimize the drum drying.
采用先活化剂浸泡活化在干燥热解炭化的化学活化法制备污泥含炭吸附剂。
A technology of dipping , chemical activation-drying-pyrolysis, charring used for manufacturing activated carbon adsorbents from sewage sludge was discussed.
通过试验考察了污泥种类、含水率、干燥方式及热干燥温度等因素对污泥热干燥过程中粘壁量的影响。
The influence of sludge type, sludge moisture content, drying method and thermal drying temperature on sludge adhering quantity during thermal drying was investigated through experiment.
对桨叶式干燥机干燥污泥提出死角改良、受热面尾缩等六个改良建议。
The heating surface, improvement of the dead angle and so on, the advise was laid out for sludge after the several experiment.
转筒干燥机是一种适合污泥工业干燥的推广机型,但缺少模型指导污泥转筒干燥过程,使其进一步推广受到限制。
Rotary dryer is suitable to be promoted for civil sewage sludge industrial drying, but the lack of model to direct the rotary sludge drying process to cause its further promote limited.
本文在确定印染污泥的干燥目标为含水率30%后,对印染污泥的干燥工艺进行了探索和研究。
In this article, the printing and dyeing sludge need to be dryed to moisture content of 30%. Then the drying technology of printing and dyeing sludge was explored and researched.
干燥温度越高、污泥颗粒越小,干燥至一定的含水率所需的干燥时间越短,恒速干燥阶段的干燥速率越高。
The higher the drying temperature and the smaller the particles of sludge, the shorter time be needed to dry to a certain moisture content and the higher drying rate in constant rate drying stage.
本文采用计算机模拟方法考察了污泥转筒干燥过程。
The computer simulation method was used to investigate the rotary drier sludge process.
研究了污泥间壁热干燥的工艺过程,分析了其工艺参数、冷凝水水质和产生的污染气体,探讨了有机物水解机理。
Technical parameter, condensed steam water quality and flue gases were studied and organic compound hydrolysis mechanism was discussed.
研究了污泥间壁热干燥的工艺过程,分析了其工艺参数、冷凝水水质和产生的污染气体,探讨了有机物水解机理。
Technical parameter, condensed steam water quality and flue gases were studied and organic compound hydrolysis mechanism was discussed.
应用推荐