根据4月21最终试验的结果,机翼和后缘的承受的极限负荷为2.5g左右,而实际最高负荷只能在实际服役的时候才能知道。
The final test occurred Apr. 21 when the wing and trailing edges were subjected to their limit load of around 2.5g, the highest loads expected to be seen in service.
静态最接近电压稳定极限就是对应于负荷沿某一最坏的可能方向增加时的静态电压稳定极限。
The static-state closest voltage stability limit corresponds to power limits of voltage stability when the loads in-crease along with the worst possible direction.
推力轴承只能承受轴向负荷,极限转速低。有单向推力和双向推力两种受力方式。
The thrust bearings are capable only to sustain the axial loads, with low limit speed. They have two stress modes, I. E. One-way thrust and two-way thrust.
开裂和挠度,因此在钢筋混凝土的成员基本上是无法挽回的,一旦在业务负荷已达到其极限状态。
Cracking and deflection are therefore essentially irrecoverable in reinforced concrete once the member has reached its limit state at service load.
什么是近似基金会负荷?有变形或挠度极限超过平常的要求吗?
What are the approximate foundation loads? Are there deformation or deflection limitations beyond the usual requirements?
负荷越靠近发电机,系统电压将越不易发生振荡失稳,但鞍结分岔对应的最大功率传输极限将减小。
When the load is near to generators, the possibility of voltage collapse caused by system voltage oscillate and the power limit corresponding to saddle-node bifurcation will decrease.
仿真计算结果表明,采用考虑配电网络综合负荷模型与电力系统当前采用的综合负荷模型的传输功率极限比较接近。
Simulation results showed that the comprehensive load model considering the distribution network with the power system of comprehensive load model using the ultimate closer to the transmission power.
我们提出的极限分析方法是在概念上的简单:我们根本目的是最大限度地利用负荷因素根据同一套条件将适用于一个完整的分析。
Our proposed limit analysis approach is conceptually simple: we simply aim to maximize the load factor under the same set of conditions that would apply to a holonomic analysis.
这样一来,便可100%地达到吊索的额定工作负荷极限。
This allows 100% of the slings rated Working Load Limit to be achieved.
每个卸扣上都显示工作负荷极限,永久不掉。
推力球轴承不能承受径向负荷,极限转速较低。
Thrust ball bearings can bear radial load, lower speed limit.
本文研究了自动调心分离轴承装置的结构和调心原理,分析了弹性元件载荷与变形的关系,给出了分离轴承接触角和极限轴向负荷的确定方法。
The relation between load and deformation of the spring element is analysed and the calculating methods of constant angle and maximum axial load are set up.
利用该算法可以很方便地解出临近电压稳定极限的重负荷潮流和电压静稳极限。
With the algorithm it is very easy to find out the power flow under heavily loading condition, as well as the static voltage stability limit.
通过对单机。动态负荷模型添加无功功率动态补偿装置,可以改变原系统的分岔点,增加了负荷极限,从而提高了系统电压稳定性。
Through the single-dynamic load model dynamic reactive power compensation device can change the original system bifurcation point, increase the load limits and improve the system voltage stability.
定子绕组附加铜损耗由计算得到,而矩形空心导线的极限带热能力即极限热负荷由实验获得。
The additional copper losses were calculated and the utmost heat burden was obtained through the model experiment.
低负荷性能好,理论板数随气体负荷的降低而增加,几乎没有低负荷极限;
The number of theoretical plates increases as the gas load decreases, almost no limit of the lowest load capability;
例如,可以随时估测负荷量,输出电压变化以及承载极限。
This allows, for example, evaluation of the load, output voltage changes or brake chopper threshold at any time.
第四章是文章的核心,对所描述的高负荷带放弃的网络模型建立模型并进行模型分析,得到负荷过程的高负荷极限。
The fourth chapter is the core of the article. Described on the network model with abandonment in heavy traffic and analysised the model and gave the approximation of the load process.
第四章是文章的核心,对所描述的高负荷带放弃的网络模型建立模型并进行模型分析,得到负荷过程的高负荷极限。
The fourth chapter is the core of the article. Described on the network model with abandonment in heavy traffic and analysised the model and gave the approximation of the load process.
应用推荐