但是，以最大速率进行适应，要求承受的应力达到您身体的极限。
But adapting at the maximal rate requires that your body be stressed to its limit.
将采场顶板简化为岩梁模型，岩梁的最大拉应力及其极限跨距是采矿工程涉及到的两个重要参数。
The roof in working areas is simplified as rock beam, the maximum tensile stress and limited span of rock beam are important in mining engineering.
最危险点在接头的第一啮合齿的齿根处，最大应力应变值一般均超过屈服极限。
The most dangerous point is at the root of the first engaged tooth of a joint. Generally, the biggest values of stress and strain may exceed the yield limit.
结果表明：最大应力值接近铝合金车轮的强度极限，充分利用了材料，有效的减轻了重量，应力分布更加合理。
Therefore, this design makes material sufficiently used, the weight of road wheel effectively lightened. at the same time, stress distribution is more reasonable.
通过岩石试件的能量有一个最大的极限，该极限实质上是一个应力幅值的极限。
A maximum limit of the energy which can be transmitted through a rock specimen was found.
统计分析表明：中间主应力一般可使最大主应力的强度极限增大30%。
The statistical analysis shows that the intermediate main stress can generally make the maximum main stress increase 30%.
主梁下挠变形的主要原因是受热引起的最大复合应力超过许用值，达到了屈服极限值，强度不满足要求。
The main reason of the main beam down deflection was that the most complex stress exceeded the admissible value and achieved the yield limit value.
地面支承架和大反力支承架在极限荷载作用下的最大等效应力均小于材料的屈服强度。
The most equivalent stress of the ground supporting frame and the large reaction wall under the action of the ultimate load was less than the yield strength.
线弹性及非线性分析结果表明，最不利工况下，部分节点局部区域的峰值应力有超过铸钢屈服极限的情况，但屈服区域范围小，同时最大应变值尚小。
Though the peak value of the stress in part areas exceeds the yield limit of the cast steel, as the yielding areas are small an.
分析在正常使用极限状态下截面内力分别为最大负弯矩和最大正剪力两种工况下应力分布规律。
Then take three-dimensional simulation for the model, and analyze the stress distribution when conditions maximum positive shear or maximum nagetive moment happens.
对布料溜槽鹅头进行静力分析，计算出的最大应力远小于鹅头材料的强度极限，表明鹅头的失效原因不是由于静强度不足。
The stress of chute head has been studied in this paper. The simulation show that the stress of chute head is far under the strength of material.
最后分析了双舷侧宽度对极限弯矩和最大剪应力的影响，提出了选取双舷侧宽度值的建议。
The results indicate that if introducing the double-hull board side structure, the shearing stress will be greatly decreased, while the effects on improvi…
最后分析了双舷侧宽度对极限弯矩和最大剪应力的影响，提出了选取双舷侧宽度值的建议。
The results indicate that if introducing the double-hull board side structure, the shearing stress will be greatly decreased, while the effects on improvi…
应用推荐