人类旋转螺丝使其前进，而象鼻虫的肌肉沿着腿的方向牵拉，使其旋转。
Humans turn a screw to make it move along its length, but the weevil's muscles pull along the length of its leg to make it turn.
第三步：从底座方向上再取下螺丝
通过消除四个埋头螺丝保持精确一致，该活塞杆和模具板可旋转方向没有拆卸气缸90度。
By removing the four countersunk screws that maintain exact alignment, the orientation of the piston rods and tooling plate can be rotated 90 degrees without cylinder disassembly.
如果要降低水压，则逆时针方向旋转调节螺丝。
To lower the reduced pressure - turn the adjusting screw counterclockwise.
如果要升高减少的水压，则慢慢顺时针方向旋转调节螺丝直到系统压力表指示达到所需压力为止。
To raise the reduced pressure - slowly turn the adjusting screw clockwise until the system gauge indicates the pressure required.
第二种安装方式如图2 所示，T形槽螺丝定位安装，在长度L方向可以任意调整安装位置。
The second installation method as shown in Figure 2, the T-shaped slot screwdriver positioning installation, length L in the direction of the installation position can be adjusted.
如果二个架设螺丝钉被需要，翻译相反的方向的阶段在另一个架设洞之一上面排成一行。
If two mounting screws are desired, translate the stage in the opposite direction to line up one of the other mounting holes.
如果需要调节，则用螺丝刀从两个方向慢慢旋转调节控制，直到振动或蜂鸣声停止。
If adjustment is required, turn adjustment control with screwdriver in either direction slowly until vibration or hum stops.
左右旋转机构：更换置物方向时方便调整，仅调整螺丝即可，不需要换气管及磁簧开关。
The left-right rotating institutions: replacement stowage direction convenient adjustment, only adjustment screws can, do not need to change the trachea and magnetic reed switch.
如果不轻，使用一个小螺丝起子把r 8反顺时针方向行驶，直到灯熄灭。
If it does light, use a small screwdriver to turn R8 counter-clockwise until the lamp goes out.
换赛车方向盘——没了安全气囊，要是还懒得绑安全带，40KM磕碰就会一头撞在MOMO中心的螺丝上归西。
19 for racing wheel -- no airbags, if too lazy to tie the seat belt, 40KM will hit a bump dead in the centre of MOMO screw.
换赛车方向盘——没了安全气囊，要是还懒得绑安全带，40KM磕碰就会一头撞在MOMO中心的螺丝上归西。
19 for racing wheel -- no airbags, if too lazy to tie the seat belt, 40KM will hit a bump dead in the centre of MOMO screw.
应用推荐