提出巴西圆盘劈裂试验中拉伸模量的解析算法。
An analytical algorithm to estimate the tensile modulus of Brazilian disk splitting tests is presented.
然而复合材料的拉伸模量随着成型温度的升高有一定幅度的提升。
Meanwhile, as the curing temperature increases, the tensile modulus of composites improves in some degree.
结果表明，随着温度的降低，该橡胶的拉伸强度、拉伸模量升高，耐寒性下降；
The results show that tensile strength and tensile modulus increase and cold-resisting property descends with temperature dropping.
研究了碳纳米管的加入量与分散程度对复合材料的拉伸强度、拉伸模量、断裂伸长率的影响。
The effects of the content and dispersion of carbon nanotubes on the tensile strength, tensile modulus and ratio of elongation of the nanocomposites were studied.
本文讨论了常温固化不饱和聚酯树脂浇涛体的拉伸强度、拉伸模量、断裂延伸率与固化度之间的关系。
In this paper, the relation of tensile strength, tensile modulus and breaking elongation of unsaturated polyester casting matrix cured at room temperature to curing degree was discussed.
随着VP-501含量的增加，体系在RT和77K下的断裂韧性增加了，然而其拉伸模量降低了。
With VP-501 content increasing, the fracture toughness was increased, while the tensile modulus was decreased at both RT and 77 K.
研究结果表明，浆膜断裂伸长率和断裂比功大的。拉伸模量小的浆料上浆的浆纱耐磨性较好，织造性能也较比良。
Results show that yarns sized by sizes with films of higher breaking elongation and specific work of rupture and lower initial modulus have better abrasive resistance and weaving performance.
结果表明：随温度升高，定向有机玻璃的拉伸强度和拉伸模量降低，断裂伸长率增加，材料由刚而脆变得软而韧。
The result shows with the temperature increasing, tensile strength and modulus decreases but elongation increase and material properties change from rigidity to flexibility.
而本体法复合材料的拉伸强度、拉伸模量及冲击强度值最大分别提高了32.2％、60.3％和68.6％，而透光性能基本未受影响。
In the bulk system, tensile strength, tensile modulus and impact strength are improved by 32.2%, 60.3% and 68.6%, respectively, without the loss of light transmittance.
计算了含有纤维端头裂纹的单向短纤维复合材料的有效纵向拉伸模量和纵向剪切模量，并分析了体分比、刚度比、长径比等物理、几何因素的影响。
The self-consistent finite element method is used to evaluate longitudinal effective Young's modulus and shear modulus for unidirectional fiber composite containing the fiber-end crack.
结果表明光纤的编入对材料的拉伸弹性模量和压缩弹性模量影响也较小。
Results show that co-braided optical fibers have just a small quantity of effect on the elastic modulus of the braided composites.
拉伸载荷模量约等于比例极限内的弹性模量。
The tensile modulus approximately equal to the compressive modulus of elasticity within the proportional limit.
文章介绍了一种利用普通的智能电子拉力试验机配以计算机来计算塑料薄膜拉伸弹性模量的方法。
This article introduces a method to determine the plastic membrane tensile modulus by using a normal mart electron tensile testing machine and computers.
测定了低温下聚氨酯硬泡沫塑料拉伸、剪切和压缩弹性模量与泡沫密度、方向以及温度的关系。
Measurements have been made to determine the relation of the tension, the compression and the shearing of PUR foam at low temperature with its density, direction and temperature.
结果表明，采用复合增塑剂，大豆蛋白塑料的拉伸强度，杨氏模量均增加。
The results showed that the tensile strength, Young's modulus of soy protein plastics with complex plasticizers increased.
测试了塑木板材的拉伸强度、弯曲强度、冲击强度、拉伸弹性模量、弯曲弹性模量等力学性能；
The tensile strength, bending strength, impact strength, tensile modulus of elasticity and bending modulus of elasticity were determined.
通过湿热老化试验，研究了APMOC纤维吸湿性能、拉伸强度、断裂延长率以及弹性模量随老化时间的变化。
The changes of moisture absorption properties, tensile strength, fracture elongation and elastic modulus of APMOC fiber with aging time were investigated through the hygrothermal aging test.
结果得出了对照组和实验组动物肘关节尺神经拉伸最大载荷，最大应力，最大应变，弹性模量等数据。
Results We got out the data of stretch ultimate load, maximum stress, maximum strain, elastic modulus on elbow joint ulnar nerve between control group and experimental group.
随着共混物中弹性体质量分数的增加，共混物的拉伸强度和弹性模量降低，扯断伸长率增大。
With the increase of elastomer content, the tensile strength and elastic modulus of the blends decreased, while the elongation at break increased.
到目前为止，仅通过拉伸、压缩或弯曲试验测得了木材的静弹性模量。
So far, we have found that the static elastic modulus of wood can only be measured through the experiments of tension, compression and bending.
沿着纤维长度有很强结合力的共价结合在这个方向上给予复合材料很高的模量，因为要损坏或拉伸纤维就必须破坏或移除这种结合。
The strong covalent bonds along the fiber's length give them a very high modulus in this direction because to break or extend the fiber the bonds must also be broken or moved.
本文对瓦楞纸板的拉伸和压缩性能及弹性模量的测定作了实验分析。
An experimental analysis of the tensile and compressive properties and the measurement of the in-plane elastic moduli of corrugated boards is presented in this paper.
提出了获取脆性材料动态拉伸强度及弹性模量的实验步骤及相关记录数据的分析方法。
An experimental procedure and accompanying method for analyzing recorded data for deriving dynamic tensile strength and elastic modulus of brittle material is presented.
并根据此测量原理，将光电光杠杆应用于拉伸法杨氏模量测量仪中，设计了一种高精度杨氏模量智能测量系统。
According to this measuring principle, photo-electric optical lever is used in pulling and stretching measuring instrument to develop a high-accuracy intelligent system to measure Youngs Modulus.
结果表明，复合材料的拉伸强度、曲强度和弯曲模量随着云母用量的增加而提高。
The results showed that the tensile strength, flexural strength and flexural modulus increased obviously with increase of amount of Mica.
通过拉伸试验数据得到应力—应变曲线和模量—应变曲线可以更全面地反映纤维的力学性能。
The modulus-strain curve educed by the treatment of tensile test data is more suitable for examining the mechanical properties of yarns than the stress-strain curve itself.
研究结果表明，复合材料拉伸弹性模量随增强体含量增加而升高，断裂延伸率下降。
It is shown that the elastic modulus increases with volume fraction of ceramic particles, though the fracture strain decreases.
本文比较了涤纶长丝的单丝拉伸与复丝拉伸的断裂强度、断裂伸长及分布和初始模量。
The paper studied difference of mechanical properties between single fiber drawing and multifil drawing of PET filament.
拉伸弹性模量与压缩弹性模量有明显差异，木质部属各向异性材料，建立力学模型应采用各向异性的本构关系。
There is a distinct difference between tensile and compressive modulus. Xylem is a kind of anisotropic material and modeling its mechanical model needs anisotropic constitutive relations.
拉伸弹性模量与压缩弹性模量有明显差异，木质部属各向异性材料，建立力学模型应采用各向异性的本构关系。
There is a distinct difference between tensile and compressive modulus. Xylem is a kind of anisotropic material and modeling its mechanical model needs anisotropic constitutive relations.
应用推荐