本浆料可印刷在陶瓷基片上，通过高温烧结后得到高应变系数的厚膜力敏传感器。
The inventive slurry can be plated on the ceramic basic plate to be sintered in high temperature to prepare the thick-film force sensor with high gage factor.
随着极化电场的升高，PVDF压电薄膜的压电应变系数升高，介电常数升高，介电损耗降低。
The piezoelectric strain coefficient and the dielectric constant of PVDF films increased, and the dielectric loss decreased with the increasing of the polarization field.
用力敏模型解释了这一现象，并解释了其他力敏现象，诸如应变系数随势垒高度的增大而增大。
We interpreted this phenomenon through the strain sensitive model, and explained the other strain sensitive phenomenon, such as the GF mounts up with the barrier height' s augmention.
低于玻璃应变温度，互扩散系数几乎不依赖玻璃中的氧化钠浓度，而略随离子交换时间增加而增大。
Below the glass strain temperature, interdiffusion coefficients are almost independence of sodium oxide concentration in the glasses and somewhat increase with long ion exchange time.
岩石基质渗透系数和孔隙率通过体积应变进行更新。
The permeability coefficient and porosity of rock are updated by volumetric strain.
试验结果还说明复合材料边缘有提高应变集中系数的效应。
The experimental result also shows that composite edge has the effect of increasing strain concentration factor.
本文采用大子样、小子样抽样理论的数理统计方法，评定电阻应变计灵敏系数的精度等级。
The rank of accuracy of electric resistance strain gage factor is evaluated according to the sampling theory of large samples or small samples.
根据土水特征曲线可以确定非饱和土的强度、体应变和渗透系数，甚至可以确定地下水面以上水份分布。
Strength, volumetric strain and permeability coefficient, and even moisture-distribution above ground water surface can be determined by the soil-water characteristic curve.
该方法不仅能够考虑土的应力应变性质，而且能够在任意时刻确定最危险滑动面的位置及安全系数。
The method not only can consider behavior of stress strain of soil, but also can determine the most dangerous slip surface and its factor of safety at any time.
采用等强度梁、挠度计、并联电阻箱、电位差计等测定电阻应变计的灵敏系数是一种常用的方法。
Shunting resistance box is a commonly used method in the determination of the sensitivity coefficient of the resistance strain gauge with the equal-strength beam aparatuses.
获得了应变集中系数和弹塑性边界区随载荷变化的规律；
The variation of the strain concentration factors and the yield boundaries with loading levels were determined.
基于对抗力折减系数的参数研究结果，无论钢筋的应变水平如何，建议取固定值0.90。
The resistance reduction factor is suggested as a fixed value of 0.90, regardless of the strain level of the tensile steel reinforcement.
由于有限元计算方法考虑了岩土的应力——应变关系，因此，其求解的边坡稳定系数比其它方法更为精确合理。
Because the finite element method consider the relation of stress-strain of rock soil, so, it is more accurate and rational than other methods that it calculates side slope stability coefficient.
应变率敏感系数是宏观塑性动力学和位错动力学的一个基本概念，本文试图对其进行了重新解释。
An attempt is made to elaborate the definition of the coefficient of strain-rate sensitivity, which is a fundamental concept for macroscopic dynamic plasticity and dislocation dynamics.
并对随形状改变比能参量S变化的应变释放系数塑性修正公式进行了推广。
The test of the strain release coefficients was simulated, and the energy parameter S was obtained based on the FEM analysis resu.
渗透系数依赖于塑性剪切应变(率)。
The permeability coefficient is dependent on the plastic shearing strain (ratio).
最后，绘制了试样轴向应变与动孔隙水压力系数的关系曲线，并分析了曲线的变化规律。
Finally, the curves of axial strain and dynamic pore water pressure coefficient were figured and analyzed.
应力-应变等时曲线线性回归函数的相关系数均高于0。
The correlative coefficients of linear regression function for isochronous stress-strain curve are all higher than 0.
介绍了采用等强度梁和与测量片并联电阻的方式测定电阻应变片的灵敏系数的方法。
It introduced the methods of measuring the sensitive coefficient of the strain gauge of electrical resistance by means of equal-strength beam and the parallel connection with the measure gauge.
并通过实验标定ASE光源谱特性解调应变灵敏度系数。
The strain sensitivity was demarcated by experiment using spectrum character of ASE demodulation.
分析了从傅里叶系数或真实线形分离晶粒尺寸和微观应变的可靠性；
The reliability of the separation of size- and strain-broadening from Fourier coefficients or deconvoluted profile is estimated.
通过应变分布影响系数把应变疲劳与应力疲劳联系起来。
Strain fatigue and stress fatigue are related by the influence coefficient of strain distribution.
给出了板料弯曲的应力应变中性层和纯弯曲应变中性层的计算公式，并推出板料弯曲时的变薄系数计算公式。
The computation expression for the strain neutral layer of stress and plastic bending was introduced and so the thinning coefficient computing formula of sheet metal was deduced.
混凝土内部应力测量关键在于应力应变转换，而应力应变转换关键在于徐变系数的识别。
The key to concrete stress measure is the translation from strain to stress. And the transition 's key is the identification of creep factor.
详细地探讨了应变片法测量材料线膨胀系数的原理。
The principle of the strain gauge technique for thermal expansion measurement was systematically investigated.
根据夹层板的正应力、正应变和剪应力、剪应变沿板厚的分布关系，得到夹层板的弯曲、剪切修正系数。
The bending and shear modifying coefficients are derived according to the distribution of the stress and strain of the sandwich plate along the direction of the plate thickness.
用电阻应变仪对布拉格光栅光纤传感器应变传感特性进行实验对比标定，得出了表征fBG性能的应变传感灵敏系数。
A calibration test has been performed on FBG with strain gauges, and the strain sensing sensitivity coefficient of the properties of FBG was gained.
用电阻应变仪对布拉格光栅光纤传感器应变传感特性进行实验对比标定，得出了表征fBG性能的应变传感灵敏系数。
A calibration test has been performed on FBG with strain gauges, and the strain sensing sensitivity coefficient of the properties of FBG was gained.
应用推荐