输入信号作用于一个以模拟调制器为基础的专有可编程增益前端。
The input signal is applied to a proprietary programmable gain front end based around an analog modulator.
文中主要阐述可编程增益的研究，包括硬件构成、软件设计和信息后处理。
In this paper, the studies on programmable gain is described detailed including the hardware structure, the software design and information post processing.
可编程增益运算放大器的电压增益变化可以通过数字控制的开关电阻网络来实现。
The variation of voltage gain of the PGA can be realized by switched resistor-network, which is digitally controlled.
该可编程增益放大器采用源极反馈电阻可变的差分放大器结构，且带有直流漂移校正电路。
The PGA consists of the differential amplifier with variable source degeneration resistor and the DC-offset correction circuit.
LTC 6915是具有14级可编程增益的仪表放大器，采用轨对轨输出，其增益可通过串行或并行接口方便设置。
The LTC6915 is a precision programmable gain instrumentation amplifier with rail - to - rail output. The gain can be programmed to 14 levels through a parallel or serial interface.
主要优点失真小，放大倍数高以及增益大小可编程控制。
Its main advantages are low distortion and high magnification times. In addition, its gain magnitude can be controlled through programming.
该图像传感器集成了一个可编程偏移和增益为每32LVDS输出通道放大器。
The image sensor integrates a programmable offset and gain amplifier for each channel of the 32 LVDS outputs.
系统显示采用了点阵式液晶显示器，增益曲线现场可编程，并带有遥控功能。
The system uses dot matrix liquid crystal display . and the gain Curve is field programmable with a remote controller in the system.
介绍了一种基于可编程片上系统（PSOC）的宽量程电能计量模块（EPSOC）的结构与原理，分析了自调增益算法及同步采样算法。
Structure and theory of wide magnitude electrical energy measurement module based on PSOC (EPSOC) are introduced in this paper, adjustable range algorithm and synchronous sampling are analyzed.
本文重点介绍了KD1411的以下三个主要特点：（1）增益可编程控制的微弱信号放大器的设计；
This paper lays stress on the description of the three main features of KD1411: 1. the design of weak signal DC amplifier with programmable gain;
本文针对增益为20～ 23倍的可编程阶码放大器AD5 2 6集成片，摆脱传统的设计方法，提出一种反馈式程控放大电路。
This paper introduces a special amplifying circuit which can vary the gain from 2 0 to 2 3 in allusion to AD526 chip, throwing out of the traditional method.
以现场可编程门阵列（FPGA）为载体的可自动增益调整CCD驱动电路。
A kind of driver circuit of CCD for the auto-gain regulation is researched and manufactured on field programmable gate array (FPGA).
以现场可编程门阵列（FPGA）为载体的可自动增益调整CCD驱动电路。
A kind of driver circuit of CCD for the auto-gain regulation is researched and manufactured on field programmable gate array (FPGA).
应用推荐