清单7和8展示了一个CIM - XML消息交换的范例——通过CIM适配器使用叠加方法中的CIMOM(基于HTTP)来进行请求和响应。
Listings 7 and 8 show a sample CIM-XML message exchange — request and response — with the CIMOM (over HTTP) in the push-down method through the CIM Adapter.
所示的激励激起了所有阶模态，因此就一般情况下，响应是输入激励激发起来的所有阶模态的线性叠加。
The excitation shown causes all the modes to be activated and therefore, the response is, in general, the linear superposition of all the modes that are activated by the input excitation.
利用惯性过程的阶跃响应特性和线性系统中的叠加原理，提出了纯滞后过程的模糊预估模型。
Using the step response behavior of inertia process and the superposition theorem of linear system, this paper puts forward a fuzzy predictive model of dead-time processes.
应用模态叠加法研究了用粘弹性阻尼控制加筋板的稳态简谐响应。
The viscoelastic damping control of steady-state harmonic response of stiffened plate is studied by using modal superposition method.
最后进行了动态分析，对冲击载荷进行了研究，采用模态叠加法对典型工艺的动态响应进行计算。
Finally, in dynamic research, the impulsive loads of the frame are studied and dynamic response of the typical process is calculated and analyzed with modal superposition method.
利用复数振型叠加法，这种求解方法能够得出结构动力响应的精确解。
The proposed approach can offer an exact solution for dynamic response of base-isolated structure, through using the complex mode superposition method.
分别采用直接法和模态叠加法，计算声场-结构耦合系统的声压响应水平及其敏度。
The modal frequency response and its sensitivity analysis for the coupled system using the direct method and the eigenmodes.
结构物对爆破振动荷载的动态响应，是其对于不同优势频率的细节信号的不同的动态响应的叠加的结果。
Under blasting vibrating load, the dynamic response of the structure results from the superposed results of its dynamic response to various dominating frequency detail signals.
应用叠加原理建立了变流压条件下不稳定流量响应的数学模型。
Applying the superposition principle, the transient rate's mathematics model under the variable flowing pressure condition has been introduced.
扰动状态理论利用硬化模型并叠加扰动因子得到软化响应。
Softening response was obtained with DSC by utilizing hardening model and introducing disturbance factor into the response depiction.
目前对此虽然已经有较多研究成果发表，但多数以简支桥梁为研究对象，采用效率不高的数值方法或者解析方法求解随机响应，分析过程中普遍采用模态叠加法。
Some research papers have been published. However, most of these papers used relatively simple bridge models and adopted analytical solution or inefficient numerical method to get stochastic response.
格林函数法是将任意源激励的响应表示为空间各点激励源响应的叠加。
Green function method is the approach that arbitrarily response by the source excitation is expressed as superposition of excitation source at all space point.
声频设备附近的墙壁会反射声波，空气中的声波叠加，产生频率响应误差(亦称梳状滤波器)。
Nearby room boundaries can create frequency response errors (called comb filtering) due to wave reflections combining in the air.
在此基础上提出结构总的背景响应和总共振响应可以分别采用各自主要参振模态的SRSS组合结果再叠加强模态耦合项的贡献得到。
The total wind induced background and resonant response can be obtained by the superposition of dominant-coupling modals and SRSS results of each dominant modals.
研究钢筋混凝土梁的动刚度随外荷载的变化规律，对准确分析其动力响应有极其重要意义。采用振型叠加法，导得了弹性加载纯弯梁的动力分析理论，给出了确定梁动刚度的方法。
In this paper the theory of dynamic analysis is proposed by adding again and again normal modes of vibration of rc (reinforced concrete) beams under the elastic loads, and an example is given.
研究钢筋混凝土梁的动刚度随外荷载的变化规律，对准确分析其动力响应有极其重要意义。采用振型叠加法，导得了弹性加载纯弯梁的动力分析理论，给出了确定梁动刚度的方法。
In this paper the theory of dynamic analysis is proposed by adding again and again normal modes of vibration of rc (reinforced concrete) beams under the elastic loads, and an example is given.
应用推荐