引入装置为密封圈压紧螺母式。
The cable entry is sealing ring clamp nut with good sealing performance.
如果阀杆周围出现泄漏，则轻轻紧固压紧螺母。
注：如果出现少量的泄漏，则拆卸锁紧螺丝，然后锁住垫圈和阀盖，然后轻轻紧固填料压紧螺母。
NOTE: If minor leakage occurs, remove lock screw, lock washer and cap and lightly tighten packing gland nut.
检查所有基础上的螺母和压紧装置的螺栓是否松动。3.2安装规定每三月把齿轮箱的油更换一次。
1 check all the nuts and bolts compaction device on the basis of whether is loose. 3.2 installation regulations every march the gearbox oil replacement.
锁紧螺母扭矩压紧垫片时，其与垫片的最大相互作用力不能超过表3所给扭矩值。
The locknut torque needed to move the washer at the maximum washer interference fit shall not exceed the torques given in Table 3.
杆体上对应于每套压紧件中的托盘和螺母之间处均套装一个垫圈。
On the rod body, a washer is sheathed with the part which is corresponding to the part between the tray and the screw nut of each compressing piece.
在安装期间，手动紧固管接螺母用来压紧Chemtrol阀门的表面密封。
Upon installation, a hand-tightened union nut serves to compress the face-seal of a Chemtrol valve.
阀杆、塔型盖、格兰通过填料压紧密封，阀杆与执行机构通过固定于支架上的推力螺母实现上下运动。
A valve body is connected with a tower cover through soft seal, and pressed by a bracket through a bolt. The valve rod, the tower cover and a gland are pressed and sealed by filler.
阀杆、塔型盖、格兰通过填料压紧密封，阀杆与执行机构通过固定于支架上的推力螺母实现上下运动。
A valve body is connected with a tower cover through soft seal, and pressed by a bracket through a bolt. The valve rod, the tower cover and a gland are pressed and sealed by filler.
应用推荐