井架压溃试验发现：井架破坏发生在井架上段；
The collapse test shows that the breakdown occurred on the upper portion the derrick.
截顶圆锥壳的破坏过程是一个从屈曲破坏直至压溃的过程。
The destroyed process of the truncated conical shell is from buckling to collapse.
在篮板后设加长定位板，篮板不会压溃，可使篮圈平面与篮板永远保持垂直。
A lengthened locating plate is arranged at the back of a backboard, and the backboard can not be pressed to ensure that the basketball hoop plane can keep vertical to the backboard forever.
在船舶碰撞和搁浅中，薄壁结构在轴向压力条件下的压溃破坏是一种重要的破坏模式。
During the ship collision and grounding, the crushing collapse of thin-walled structure subjected to compressive load is one of the important failure modes.
机械性能的变化趋势是：密度增加，含油率下降，布氏硬度增加，而压溃强度先降低后增加。
Development tendency of mechanical properties is: density increase oil content ratio decreases, Brinall hardness increases, crushing strength goes down first and then goes up.
分析铝电解多功能天车轨道接头局部压溃的原因，介绍采用手工堆焊工艺修复方案之全过程。
The paper analyzes the reason for the rail connection squished and recommends the process of restoring the track applying the built-up welding technology.
本文用非线性有限元方法研究了准静态条件下纵向和横向加强筋对加筋方形管压溃破坏的影响。
The effects of longitudinal and transverse stiffeners on quasi-static crushing of stiffened square tubes are studied with the nonlinear finite element method.
钢轨侧磨与压溃是重载曲线段钢轨的主要损伤类型，而高速铁路钢轨主要表现为疲劳损伤特征；
The results indicate that the wear of gauge-rail and the plastic flow are dominant for heavy-haul curve rail, and the fatigue behavior is primary for high-speed rail.
竹子在切片前先通过一对压榨辊使竹子在进入切片机前被压溃，竹片的筛选和木片筛选几乎一样。
Bamboo is handled by chippers equipped with a pair of press rolls to crush them before being chipped. Bamboo chips are screened in almost the same ways as wood chips.
基于验证的有限元模型，研究薄弱环节设置、复合材料纤维铺层角度对其轴向压溃吸能特性的影响。
The influences of triggers and composite ply angles on energy-absorbing characteristics of aluminum-composite hybrid tubes were studied based on the verified models.
分别利用塑性铰理论和压溃理讨论了强度计算问题，提出了强度承载能力计算公式和压溃荷载计算方法。
With the help of plastic hinge theory and collapse theory, the formulas for calculating strength failure load and the method for computing collapse load were established respectively.
高耸建筑的水平环缝和竖向裂缝、钢筋砼柱的水平裂缝以及压溃破坏等震害现象，可以归结为地震竖向分量的作用；
The horizontal annular and vertical crack of the high buildings, along with the horizontal crack and the crush of RC column can be due to the vertical seismic component action.
回转窑运行中由于轴线偏差，支承载荷分配严重不均，导致支承部件因接触应力过大而产生压溃、剥落和点蚀等现象。
Because of axis line deflection and asymmetric load distribution of rotary kiln, the support parts may break, spall, or erode due to the induced overlarge contact stresses.
指出为保证该联接安全可靠，必须满足轴承座底面与游梁接合面间不滑移、螺栓不拉断、接合面不压溃及轴承座不翻转等条件。
To ensure the security of this joint, interracial sliding of the joint, tensile failure of the bolts and extruding failure of the interfaces must be prevented.
长期以来，木材皱缩现象一直被认为主要是因为木材中液体毛细张力产生的“负压强”压溃细胞壁造成的，该文对此提出了质疑。
The long-term existing theory of wood collapse which was thought to be caused by "negative pressure" resulted from capillary tension in the water capillaries was called in question.
综合考虑规范对立管强度的要求，防止发生压溃和屈曲扩展的要求及限制立管发生漂浮的要求三个条件，确定了满足条件的最小壁厚。
Considering the requirements of riser strength, system collapse, propagated buckling and limitation of floating, the smallest thickness that meets the requirements is determined.
综合考虑规范对立管强度的要求，防止发生压溃和屈曲扩展的要求及限制立管发生漂浮的要求三个条件，确定了满足条件的最小壁厚。
Considering the requirements of riser strength, system collapse, propagated buckling and limitation of floating, the smallest thickness that meets the requirements is determined.
应用推荐