桥梁工程中经常遇到双向偏心受压的砌体构件,但现行的公路桥涵设计规范却没有这方面的内容。
Biaxial eccentric compression masonry members are often used in bridge engineering, yet they are not prescribed in the present specifications for design of highway Bridges and culverts.
建议在《城市道路设计规范》修订前,应参照《公路水泥混凝土路面设计规范》来进行水泥混凝土路面设计。
The design of cement concrete pavement slabs should be consulted "Specification for Highway cement concrete pavement design" before the revision of "Specification for Urban Road design".
本文对铁路与公路桥涵设计规范有关填土荷载的计算作了介绍和对比,并提出相应的合理计算方法。
Based on the railway and highway bridge and tunnel design standards, the loading calculations of the soil filled on the top of culvert are introduced and compared, and the more reasonable calc...
另外,现行的公路桥涵设计规范,在对桥梁受弯构件承载能力计算中采用了一些基本假定,导致计算结果过于保守。
Besides, the current bridge and culvert design criterion takes some basic postulation during the calculation of the bridge's member in bending, which results in over-conservative numeric value.
我国《公路路面设计规范》对水泥混凝土路面设计温度梯度的规定很不合理。
In our "Specifications for Highway Pavement Design", codes on parameter of temperature gradient of cement concrete surfacings are not very rational.
但由于我国现行公路桥梁的抗震设计规范存在不足,致使设计细部构造时没有统一的标准。
But because of the lack of the current seismic ability design criterion of Highway bridge, there isn't a uniform standard in the bridge detailed component's seismic ability design.
代用钢筋的净距应遵守《公路钢筋混凝土及预应力混凝土桥涵设计规范》(JTGD62-2004)第六章的规定。
The clear spacing of substituted bars shall conform to Chapter 6 of Code for Design of Highway Reinforced Concrete and Prestressed Concrete Bridges and Culverts (JTG D62-2004).
本文结合苏州工业园区高架桥工程设计,对基于新、老公路桥涵设计规范的设计进行了比较分析和验算。
The design method of Suzhou industrial park overhead viaduct are introduced in this paper, and it compared new code for design with former code in the aspects of checking computations.
提出了公路线形设计规范与安全标准相融合的理念,为我国公路设计安全性审核提供参考。
A concept of the mixing of the road alignment norm with the safety standard was suggested to provide a reference for the examination and verification of the road design safety.
提出了公路线形设计规范与安全标准相融合的理念,为我国公路设计安全性审核提供参考。
A concept of the mixing of the road alignment norm with the safety standard was suggested to provide...
最后,以现行《公路柔性路面设计规范》(JTJ014, 1987)为基础,提出柔性路面可靠性设计的基本方法。
At last, based on present "THE STANDARDS OF ROAD FLEXIBLE PAVEMENT design" (JTJ014, 1987), a reliability design method has been advanced.
最后,以现行《公路柔性路面设计规范》(JTJ014, 1987)为基础,提出柔性路面可靠性设计的基本方法。
At last, based on present "THE STANDARDS OF ROAD FLEXIBLE PAVEMENT design" (JTJ014, 1987), a reliability design method has been advanced.
应用推荐