标定时可根据仪表显示的传感器信号电压进行系统检测。
While adjusting, it can measure the system according to the voltage of sensor signal that the instrument shows.
探索了X射线照片密度与显微密度计信号电压之间的关系。
The relation between the optics density of the X ray and the output information voltage of micro densimeter is investigated.
第一副像素的阈值信号电压比第二副像素的阈值信号电压低。
The first sub pixel has a threshold value signal voltage lower than that of the second sub pixel.
如果发生这种情况，就不可能区分出信号电压的变化和热电动势的变化。
If this occurs, distinguishing between a change in signal voltage and a change in thermoelectric EMFs becomes impossible.
针对铁电材料测试系统中不同测试信号电压的差别，设计了电压自动衰减电路。
In view of the different voltage used in system for measuring ferroelectric materials, the automatic voltage-decaying circuit was designed.
该电路采用恒流源供电的输入电路，提高了信号电压v _t与温度t的线性度。
The constant current supply for the input circuit is adopted, improving the linear relation between the signal voltage v, and temperature t.
由于声表面波压电效应产生的电压信号非常微弱，一般放大不能分辨出信号电压和噪声电压。
Generally, because the output voltage signal is very weak, the signal voltage and the noise voltage can't be distinguished.
偏移电压被直接叠加到信号电压之上，可以被模型化为一个未知的电压源，与已知信号相串联。
The offset voltage adds directly to the signal voltage and can be modeled as an unwanted voltage source in series with the intended signal.
其在电压与频率的同步测量、双积分整周期测量交流信号电压平均值等问题都提出了一些有创意的解决方法。
There are some inventive attempts to measure voltage and frequence synchronously and obtain average alternate voltage through dual-slope convenor in the integral times of input signal period.
另一方面，为了兼容其他那些工作输入信号电压不为0的器件，如模数-数模转换器，信号电平也许要做平移。
On the other hand, the signal may require level shifting in order to be compatible with the input of other devices (such as ADCs) that are not designed to operate at 0v input.
检测器本身具有较高的分辨力，使彼此难以分辨的多个输入信号电压中的最大(小)者与其它输入电压间的差距在输出端加大变得易于分辨。
This detector has higher resolution, which makes the differences difficult to distinguish between the minimum (or maximum) input voltage and the rest enlarged and distinguished easier.
理论分析和实验结果表明，干涉仪输出光强的幅度和频率与施加在压电陶瓷上的交变信号电压的幅度和频率有关，且在一定的条件范围内呈良好的线性关系。
Theoretical analysis and experimental results show that the amplitude and frequency of the output light intensity are linearly related to that of the sinusoidal signal voltage applied on PZT.
同样通过降低电压和频率，C1E尝试比传统C1状态(只会停止时钟信号)提供更大的电能节省。
C1E tries to provide more power savings than the traditional C1 state (which only halts the clock signal) by also lowering the voltage and frequency.
如果用来进行小电压信号测量，在多个通道进行扫描，进行测量并将数据传送倒PC进行分析这样的工作，基于PC的仪器可以很好的应付。
This approach works well for simple voltage measurements, scanning through a few channels, making the measurements, and passing the data to the PC for analysis.
这是非常有用的对于检测一信号什么时候滞留在一特定电压。
This is useful for detecting when a signal gets stuck at a particular voltage.
绝大多数的诊断故障码与计算机的输入电压或信号有关，并且作为一种永久性故障存在一段时间。
Most diagnostic trouble codes relate to the computer input voltages or signals and must exist for a specific period of time to be recognized as a hard fault.
其输出的基准信号稳定，与电源电压、温度以及工艺的变化无关。
Reference source outputs a stable reference signal which is independent of power supply voltage, temperature and process.
信号控制电缆采用能耐交流额定电压500伏以上的铜芯电缆。
Signal control cable applied the copper cored cable which may withstand 500 AC rated voltage.
对于直流电流测量﹐在电流通道串联一电流分流器﹐将电流转换成直流电压信号。
For DC current measurement, a current shunt is place in series in the current path and convert the current to a DC voltage signal.
该控制方式的指令信号通过同时检测电源电流和负载电压得到。
The reference signal in this control approach is obtained by detecting both source current and load voltage.
该传感器输出一个相应于石油含水率的电压信号，由此可测量出原油的含水率。
It can provide a voltage output signal in accordance with the percentage of water in crude oil.
在例子中对染噪的电压信号进行消噪处理，结果表明阈值的选取直接关系到消噪的质量。
The polluted voltage signal was denoised in the case, and the results show that threshold selection is directly related to the quality of de-noising.
对于交流电压测量﹐利用有效值转换电路或精密整流器电路将交流信号转换成直流电压。
For AC voltage measurement, an RMS converter circuit or a precision rectifier circuit convert the AC signal into a DC voltage.
切断电源检查信号反馈回路是否接通，电压是否正常。
Cut off power supply check signal the feedback loop is switched on, the voltage is normal or not.
前人在研究驱动信号对传感器的静电力效应时，用偏置电压极性为正—负配置的驱动信号进行研究。
The effect of electrostatic force of the drive voltage on the accelerometer had been researched when the bias voltage polarity is positive-negative configuration.
实验结果证明，该系统稳定可靠，对压力容器的应力及其它微伏级电压信号的自动测试具有推广借鉴价值。
The results show that the system is reliable, and it can be widely used in the fields of vessel pressure test and auto test of micro-scale voltage.
实验发现压阻型压力传感器的压力输出信号与外加电压并不是线性关系，存在着灵敏度电压非线性。
That the pressure signal is not linear with input voltage for pressure sensors found in experiments. The phenomenon is called electric nonlinearity for sensitivity.
主要用于变频器控制回路中微弱电压、电流信号的控制。
It is suitable for control weak voltage current signal in the frequency converter control loop.
放大器输入为电压信号，与光敏二极管产生的光电流信号成比例。调制光柱以断路器同样的频率照射光敏二极管。
The amplifier input is a voltage proportional to the photocurrent signal produced by a photodiode, which is irradiated by a modulated light beam at the same chopper frequency.
放大器输入为电压信号，与光敏二极管产生的光电流信号成比例。调制光柱以断路器同样的频率照射光敏二极管。
The amplifier input is a voltage proportional to the photocurrent signal produced by a photodiode, which is irradiated by a modulated light beam at the same chopper frequency.
应用推荐