罗盘刻度盘单独由装有晶体管的伺服系统驱动，指针由自整角机驱动。
Compass card is individually driven by a transistorized servo system and Pointers driven by synchros.
在伺服系统中要使系统能够满足所期望的性能，伺服系统驱动器直流母线电压的选择尤为重要。
To make the servo system have the expected its, it s especially important for selection of DC bus voltage in servo driver.
由交流伺服系统直接驱动的机器人关节一体化设计已成为一个重要研究方向。
One important research aspect has come into being which is robot integral joint design driven directly by AC servo system.
本论文以超精密机床用永磁同步直线电机驱动进给伺服系统位置控制器为研究对象。
In this paper, the research object is the position controller of a permanent magnet linear motor direct drive feed servo system.
重点介绍了永磁交流伺服系统的控制策略，位置检测和辨识、主电路和驱动技术等关键技术。
This article introduced emphatically the control strategy, position detection and identification, drive technique as well as main circuit of permanent magnet Ac servo system.
针对直接驱动的交流永磁直线伺服系统，提出一种基于神经元补偿控制的全程滑模变结构控制策略。
A global sliding model variable structure control scheme based on artificial neuron compensation for a direct drive AC permanent magnet linear servo system are presented in this paper.
研究了方波电流驱动的永磁无刷电机交流伺服系统。
This paper deals with an AC servo system with permanent magnetic brushless motor driven by square wave current.
给出了步进驱动器的硬件结构和步进伺服系统的运行过程。
The hardware structure as well as the movement of stepping servo system are also given.
该分割电极压电致动器可用于精密定位，尤其适合在高密度硬磁盘驱动器的磁头定位两级伺服系统中作第二级致动器。
The split morph can be used as precision positioner, especially as the secondary actuator in dual stage head positioning servo system of high density hard disk drives.
介绍了某机载雷达伺服系统，对其工作原理、基本结构、控制方案、驱动技术等进行了分析探讨。
An airborne radar servo system is introduced in the paper, and the principle, structure, control scheme, drive technology of the system are analyzed.
仿真结果表明：采用电伺服系统作为减摇鳍转鳍驱动系统是可行的，本文所设计控制器满足减摇鳍系统的性能指标要求。
The results of simulation showed that it was feasible to use electric servo system as the drive system of the stabilizer fin, and the controllers of this paper had favorable capability.
方位控制器伺服系统是一种机、电相结合的系统，机械传动装置根据控制信号驱动执行元件完成指令要求的运动。
The servo system of azimuth controller is a combine system of mechanics and electrics, the transmission mechanism drives the executive element by control signal to carry out the demanded motion.
针对直接驱动直线式交流伺服系统，提出了一种基于模糊自学习的滑模变结构控制方案。
This paper presents a sliding mode variable structure control (SMVSC) method based on fuzzy self-learning for a direct-drive AC Lin ear servo system.
分析了磁光盘驱动器聚焦与循轨数字伺服系统各组成部分的原理，并设计和实现了一套基于DSP的数字伺服控制系统。
The paper analyzes the principle of components of magneto optical disk driver focusing and tracking servo system, then designs and realizes a DSP based digital servo control system.
由交流伺服系统直接驱动的机器人关节一体化设计已成为一个重要研究方向。
One important research aspect has come into being which is robot integral joint design driven directly by AC servo system. The paper specifie…
双电机同步直流伺服系统是颤振激励系统的驱动单元，控制器作为伺服系统的核心，对整个系统性能的优劣起着非常重要的作用。
DC servo system is the drive unit of vibration stimulation system. As the core of servo system, undoubtedly controller plays an important role to the whole system performance.
大望远镜设计中，伺服系统与机械设计的关系并不局限于驱动力矩与速度的满足。
In designing a large telescope, the relation between the servosystem and the mechanism is not limited to the satisfaction in driving torques and velocities.
论述船用跟踪雷达角伺服系统在不同驱动方式下对船摇扰动隔离效果最好的方法，并对扰动模式进行了分析，指出在陀螺回路内加电流环路可进一步提高船摇隔离度。
Based on the analysis of the different interference patterns, a method in which a current loop is added in gyro loop to further improve the degree of isolating for the ship rocked is presented.
因此深入研究单通道电液位置伺服系统和双液压马达驱动系统的性能及控制策略对仿真转台的研制具有非常重要的实际意义。
Therefore, it is necessary to study the properties and control strategies of single channel hydraulic servo system and dual hydraulic motors driving system.
这些电机的设计，以适应范围广泛的应用，包括直接驱动伺服系统中，记录器的驱动器，保持转矩和高转矩低速控制系统。
These motors are designed to accommodate a wide range of applications including direct drive servo systems, recorder drives, holding torque and high torque-low speed control systems.
最后，根据伺服系统的理论模型，设计了振镜扫描器伺服驱动电路。
Finally, according to the servo model, the galvanometer scanner servo circuit is designed.
但同时直线伺服系统运行时直接驱动负载，从而增加了进给伺服系统的控制难度。
But at the same time it adds the difficulties in the aspect of the electrical control, because linear servo system run-time needs of direct drive method.
在无刷直流电动机驱动的雷达伺服系统中，采用了智能功率驱动模块(IPM)来实现功率驱动，它能够满足苛刻的环境要求，并能获得比较满意的系统性能。
Intelligent Power IC (IPM) is applied to a radar servo system, which is drived by brushless DC motor. The system can be used in harsh circumstances and get some satisfactory performance.
该系统有可能与激光器、计算机、平面驱动伺服系统一起构成一种全新的全息光栅图像制作系统。
So it can possibly build a new kind of holographic grating printer with laser, computer and planar drive, as well as a servo system.
针对直接驱动的交流永磁直线伺服系统，提出一种基于神经元补偿控制的全程滑模变结构控制策略。
In this paper, a new variable structure control method, that is, Global variable structure control (GVSC), is introduced to aero engine control system.
研究双位置驱动直线伺服系统动态同步控制，对解决多电机高精度同步进给和协调控制一类问题具有重要而普遍的意义。
The research of this problem has an important and pervasive significance for solving multitude motors high precision feed and synchronous control.
双电机直流同步伺服系统是颤振激励系统的驱动单元，控制器作为伺服系统的核心，对整个系统性能的优劣起着非常重要的作用。
Double motors DC servo system is the drive unit of flutter exciter system. As the core of servo system, controller plays an important role to the whole system performance.
驱动系统采用脉宽调制直流伺服系统。
The driving system use DC servo system of modulating pulse width.
针对直接驱动的交流永磁直线伺服系统 ，提出一种将非线性神经网络控制和滑模控制相结合构成的双自由度控制策略 。
The method of combining the state feedback of the modern control theory and the traditional PID to set up a double degree-of-freedom control system is presented.
针对直接驱动的交流永磁直线伺服系统 ，提出一种将非线性神经网络控制和滑模控制相结合构成的双自由度控制策略 。
The method of combining the state feedback of the modern control theory and the traditional PID to set up a double degree-of-freedom control system is presented.
应用推荐