本文着重介绍隔爆智能软起动开关各功能单元的工作原理。
The paper emphatically introduces the working principle of functional units of flameproof intelligent soft-start switch.
依据程序清单进行编程,写入PLC主机。调整PLC主板后面的地址开关,再软起动,机床恢复正常。
Programming according to the list, write PLC host. Adjust the address switch on the back of the PLC board, and then soft start, the machine is back to normal.
流量指示器用于声音报警,灯光报警,当流量发生时启动电机、泵等继电器或起动器开关。
Waterflow indicator used to sound alarm, light signal, actuate relays or starter switches for motors, pumps, etc., when low occurs.
流量开关用于声音报警,灯光报警,当无流量时启动电机、泵等继电器或起动器开关。
Waterflow indicator used to sound alarm, light signal, actuate relays or starter switches for motors, pumps, etc. , when no flow occurs.
机组可在断路器或负荷开关打开时,采用发电机升压变压器作为一种非本电厂电源来起动。
The unit can be started with the breaker or switch opened using the generator step-up transformer as a source of off-site power.
GEL7511能控制辊缝调整的位置,发出起动、停止开关信号。
The position controller GEL7511 can control the position of roller seam adjustment, the switch signal of start and stop.
确保从开关柜到电机驱动器的起动器有电。
Make sure that electric power is available from the switch gear to the starter of the electric motor drivers.
柜内还装有电流表、电压表、自动空气开关、指示灯、交流接触器、工频变频转换开关及起动、停止按钮等。
Inside is arranged ammeter, voltmeter, air circuit breaker, indicator, ac contactor, conversion switch, and buttons for starting or stopping.
对功率因数校正器辅助电路中的滤波电路设计、起动电流抑制电路的设计和开关的浪涌吸收保护电路的设计进行了分析。
The design of the filter circuit, starting current check circuit and switching surge absorption-protection circuit in an auxiliary circuit of PFC is analyzed.
浮球开关可以根据所需液位变化,自动控制泵的起动与停止,不需专人看管,使用极为方便。
Float switch can automatically control the start and stop of pump according to the variation of required liquid level, with no need of a special person to care about, making operation quite easy.
工作台起动有液压开关阀,确保装卸工件时的安全性。
The machine is equipped with a hydraulic switch valve to ensure safety during loading and unloading workpieces.
流量开关用于声音报警,灯光报警,当无流量时启动电机、泵等继电器或起动器开关。
Flow switch used to sound alarm, light signal, actuate relays or starter switches for motors, pumps, etc., when no flow occurs.
第三章详细介绍了软起动控制器的硬件设计,包括主电路、控制电路、驱动保护回路和辅助开关电源电路的分析和设计。
The third chapter mainly introduces the hardware design of soft starter, including the main circuit, control circuit, drive circuit, and protect circuit and auxiliary switched power design.
来让发动机顺利的启动,因此,重点检查冷起动喷油器电路,如果发现冷启动喷油器时间开关有故障。
Therefore, the focus on examination of the cold start injector circuit, and found that the cold start injector, then suspect the cold start injector time switch is faulty.
电源还设置了软起动及过流保护电路,以防逆变功率开关管的损坏。
The source is put up the circuits with the soft start and overcurrent protection to prevent the switching-transistor from breakdowning.
使用方便、起动迅速、不损伤发动机、不产生爆震,防止过多损耗电瓶及点火开关。
It can be convenient used, start the engine rapidly, do no damage to the engine and do not produce intense shock. Prevented excessively loses the storage battery and ignition switches.
转动点火钥匙,弹簧的压力使“开启”位置变为“启动”位置,起动接触器闭合,使得起动电机线圈或磁性开关与电池接通。
When the ignition key is turned against spring pressure past the on position to start, the starting contacts close. This connects the cranking-motor solenoid or magnetic switch to the Battery.
内装转换开关,用于电流60A以下的电气线路中,作为电源引入开关,并可控制电动机起动变速停止换向等。
Inside installed selector switch, can be used in the circuit below60A as power lead-in switch, and the switch cab control motorstart, change speed, stop, and commutation.
使用方便、起动迅速、不损伤发动机、不产生爆震,防止过多损耗电瓶及点火开关。
Prevented excessively loses the storage battery and ignition switches. It is suited to various petrol and diesel engines, such as automobiles, tractors, steamship, and so on.
这表明,冷起动喷油器定时开关断路,使冷起动喷油器始终不能正常工作,导致冷启动困难问题出现。
This indicates that the cold start injector time switch circuit, so that the cold start injector is not always participate in the work, leading to cold start problems.
介绍了单相电动机离心开关断开转速的微机测试系统,该系统利用单板机控制,以电动机起动电流作为开关断开信号。
The paper introduced a microcomputer measuring system that takes measurement of the cen-triffugal switch breaking speed of single phase induction motor.
由顶层起动时,驱动机芯开关跳掣的操作音量颇大。
The operation of the powertrain relay switchbox on startup from the top floor is rather loud.
由顶层起动时,驱动机芯开关跳掣的操作音量颇大。
The operation of the powertrain relay switchbox on startup from the top floor is rather loud.
应用推荐