所述像素电极或共用电极上刻有沟槽或突起;
Troughs or protrusions are etched on the pixel electrode or the common electrode.
分析结果表明,不良与像素电极放电效率相关。
The results shown the defect was correlated with discharging efficiency.
第二绝缘层由于它们附近的像素电极而具有台 阶或水平差。
The second insulating layer has steps or level differences due to the pixel electrodes in their vicinities.
像素电极通过主动元件电性连接至对应的扫描配线及数据配线。
The pixel electrodes are electrically connected with the corresponding scanning wires and data wires by the active components.
限定了像素电极的厚度、第二绝缘层的厚度和倾斜角、以及像素和公共电极的厚度。
The thickness of the pixel electrodes, the thickness and inclination Angle of the second insulating layer, and the thicknesses of the pixel and common electrodes are defined.
在第 一绝缘层上或在第一绝缘层上方形成像素电极,以及在第二或第三绝 缘层上形成公共电极。
The pixel electrodes are formed on or over the first insulating layer and the common electrode is formed on the second or third insulating layer.
作为开关器件,AMLCD中的TFT工作在饱和模式,其源极总是连接数据总线(视频),漏极接像素电极。
As a switching device, TFT in AMLCD operates in saturation mode. Its source contact is always connected to the data bus (video), and the drain to the pixel electrode.
本文讨论了TFT有源矩阵的性能,描述了在像素电极上充电或放电的电压精度要求,介绍了TFT-LCD的最新进展。
The requirements of charging or discharging voltage accuracy on pixel electrode is described. The recent progress of TFT-LCD is also reported.
要对新的帧进行几分而清除阵列,每个像素上的行和列电极就会即可切换到接地释放,或者“注射”电荷到底层。
To clear the array for new frame integration, the row and column electrodes in each pixel are momentarily switched to ground releasing, or "injecting" the charge into the substrate.
CID阵列上的每个像素可以单独通过行列电极的电子标定指数来寻址。
Every pixel in a CID array can be individually addressed via electrical indexing of row and column electrodes.
如果将P -Ink的一个层面与小数量的电解流体相结合,那么两个透明的电极之间就形成一个像素。
A pixel is built by sandwiching a layer of P-Ink, along with a small amount of electrolytic fluid, between two transparent electrodes.
所述第一电极覆盖在至少部分所述第一像素驱动电路的上方。
The first electrode overlies at least a part of the first pixel driving circuit.
因此可通过降低电极之间的介电层厚度,同时增加储存电容的电容率以及像素的开口率。
It can reduce the thickness of the dielectric layer between the electrodes and synchronously increases capacitivity of storage capacitance and aperture ratio of pixel.
第一寻址电极被分配给三个子像素中的两个,第二寻址电极被分配给其余的子像素。
The first address electrode is assigned to two of the three sub-pixels and the second address electrode is assigned to the remaining sub-pixel.
第一寻址电极被分配给三个子像素中的两个,第二寻址电极被分配给其余的子像素。
The first address electrode is assigned to two of the three sub-pixels and the second address electrode is assigned to the remaining sub-pixel.
应用推荐