根据灰色系统理论，依据试验数据建立了海水作用下混凝土的强度预测模型。
Based on the Gray System theory and the test data, a strength forecast model of concrete in seawater is established.
这里基于能量守恒原理导出了一种转子扭矩的理论计算方法，并依据试验数据对此方法进行了精确的比较分析，最后给出计算实例。
A theoretical calculating method for rotor torque based on law of conservation of energy was presented in this paper. Precise comparison between experimental and theoretical res...
这些试验数据和分析结果，为线列声纳阵水下拖缆隔振段的设计提供了技术依据。
The experimental data and analysis results provide a technologic basis to design VIM of the underwater cable in towed array sonar.
运用MS—YGP磨损试验装置测定的数据，可作为工业磨煤机的选型依据之一。
The data obtained by using the MS-YGP wear test device can serve as a useful basis for the type selection of industrial coal pulverizing mills.
依据数量分类学原理对数量分类中试验数据的函数变换的必要性进行了分析。
According to the principles of numerical taxonomy, the necessity of transformation of function of test data in numerical classification was analyzed.
以长平高速公路试验数据为依据，提出了寒冷地区高速公路沥青表层的容许空隙率的界限。
According to the test data of Changping road, it offers the limitation about porosity of the asphalt surface course on expressway in frigid areas.
利用现场试验数据进行模型计算，提出了改进穿带工艺的建议，为缩短带时间、降低穿带损耗提供了依据。
According to model computation using the on-site experimental data, Suggestions to improve threading operation were given, which would be beneficial to reducing threading time and strip head loss.
最后依据对试验数据的回归分析分别得出了集中荷载作用下超高强混凝土无腹筋简支梁和约束梁的抗剪强度回归公式。
Finally, according to regression analysis of the experimental data, the shear strength formula of super high-strength concrete unconstrained beams under point load is achieved.
本文以风洞试验数据为依据，对在任意方向水平作用下的机身、垂尾和尾桨气动特性进行了研究。
This peper is based on the wind tunnel experiment data and studies the air dynamic performance of fuselage, horizontal stabilizer and fin under level wind in any direction.
叙述了滚动球窝喷管在设计中许用接触应力的选择依据及方法，并根据以往的经验公式及其试验数据对影响许用接触应力的几个因素进行了分析。
Selection basis and method on allowable contact stress of rolling ball-socket nozzle were described. Based on empirical formula and test data, several factors affecting allowable stress were analyzed.
本文由试验得到的体温数据，分别用假设检验和时间序列分析方法，找到辨别寒热性的数学依据。
In this paper, the data of body temperature from experiment is studied by using the methods of hypothesis test and time series analysis, then the mathematical basis of identifying the nature is found.
本文尝试用参数估计的方法，依据一些钻头台架试验的数据，来反求牙齿-岩样互作用的数学模型。
This paper attempts to use the parameter estimation method to backward calculate tooth-rock sample interaction mathematical model according to some bit bench test data.
采取的技术路线是依据实测数据进行研究的试验路线。
The technology route adopted is trial route based data from factual survey.
对于试验数据方面，分析了试验台应该采集的数据参数，以及其理论依据，并用VB语言编译程序对数据进行处理。
To test data, have analyzed that tests the data parameter, which should be gathered in platform, and its theoretical foundation, and deal with the data in VB language compiler.
依据某型涡轴发动机冷运转试验数据，给出了发动机阻力矩和净力矩的计算方法。
Based on a turboshaft engine test data gathered during cold run, a method of calculating engine resistant torque and torque for acceleration was introduced.
测量精度是评价试验数据可靠性的重要依据。它是通过试验误差的分析和估算而得出的。
The measurement accuracy which is obtained through analysis and estimation of error in tests is the important basis for evaluating the reliability of test data.
由此可见，用光弹性试验方法可以得出较准确的数据，为斜交箱形框架桥的设计和理论分析提供比较可靠的依据。
So the accurate data from the photoelastic method providing reliable basis for the design and theoretical analysis of oblique frame bridge can be obtained.
通过大量的实际驾驶人员的试验数据，辨识出各种水平的驾驶员模型参数，为改进智能车控制系统的设计提供了依据。
Through the experiments of many drivers, parameters of driver model with different levels are identified, which will be helpful in improving design of the intelligent vehicle control system.
依据国家规程通过对试验数据的认真分析，总结了单相接地故障时，保证人身安全的结论和措施。
By serious analysis according to Chinese rule, the conclusion and the protection measures for human safety under Single Phase Grounding Fault (SPGF) are summarized.
以供热机组热力试验数据及修正曲线为依据，较准确地建立了表达供热式汽轮机机组热力特性的数学解析式。
According to the thermal experiment data and correction curve of heat supply units, the mathematical analysis formula of thermodynamic characteristic has been given accurately in this paper.
数据处理是飞行试验整个过程中的关键环节，数据处理结果将是飞行试验鉴定结论的核心依据。
Data processing is the key part of flight test, whose result will be kernel base of the appraising conclusion of flight test.
中毒危险评估是以毒物学、燃烧试验、化学分析等方法所获得的数据资料为依据，评估电工电子产品燃烧时使人体产生中毒危险的可能性。
Toxic hazards evaluation is conducted to evaluate the possibility of toxic hazard for human body, according to data acquired from toxicological analysis, fire testing analysis and chemical analysis.
根据试验数据拟合出了推土阻力曲线，建立了模型铲刀推土阻力在不同工作介质中的数学模型，为推土机铲刀及杆件分析系统软件的铲刀性能分析提供了依据。
A mathematical model of blade bulldozing resistance in different working media has been established according to the resistance curves regressed from test data, providing a basis for blade performa…
依据武器系统的工作原理和在实际飞行试验中得到的各种测量数据，给出了针对不同故障现象的武器系统分析方法。
Introduces the analysis method for weapon system with different failure on the basis of the operational principle of weapon system and various measurement data in the actual flight test.
试验结果表明，以超声波传感器测得的水平距离数据作为描述果树外形的依据基本可行。
The result showed that it was feasible to describe the fruiter shape by using the level distance data measured by ultrasonic sensor.
概述了“密封剂试样厚度偏差对试验数据影响的研究”课题的试验设计、密封剂试样厚度偏差与试验数据的关系，为密封剂试验结果的判别提供了一些依据。
This paper summarizes the experiment design and the nexus between sealant samples ply warp and test data. It provides some gist for distinguishing test result of sealant.
通过建立大型回转轴承装置的振动模型，以大量的试验数据为依据，提出了一套从试验条件与参数的选取到最后分析结论判定的系统方法。
Based on the vibration model and testing data, the paper provides a systematic way to not only the choice of testing parameter but also drawing the conclusion.
通过电厂烟气脱硫的单因素试验数据，揭示脱硫系统多因素间动态的内在联系与规律，为控制决策的制定提供更可靠的依据。
Internal relation of some factors were unveiled by data of single factor in FGD, which provided more reliable ground for control decision.
航空发动机试车计算机辅助试验系统中开发三分钟事件记录与回放功能可以为事后的分析提供数据依据。
The function named 3-minitue events recording and replaying in computer-aided test system for aeroengine test is able to offer data for analysis afterwards.
航空发动机试车计算机辅助试验系统中开发三分钟事件记录与回放功能可以为事后的分析提供数据依据。
The function named 3-minitue events recording and replaying in computer-aided test system for aeroengine test is able to offer data for analysis afterwards.
应用推荐