The built-in alloy wires localize a stylus on the x, y, and z axis points.
内置的合金线路将在x,y,z轴上定位输入笔的位置。
The light alloy bridge is 25 percent stiffer than traditional designs and the X rail has a 50 percent lower center of gravity for smooth, precise operation.
轻合金桥架,较传统设计刚性提高25%,X向导轨重心降低50%, 从而保证了平稳、精确的运动。
The microstructure of the alloy as well as morphology and distribution of carbides were examined by using light microscope, SEM and X-ray diffractometer.
采用光学显微镜,扫描电子显微镜及X光衍射研究了合金的显微组织、碳化物形态及分布。
The crystallization property of polymer matrix filled with low melting metals and alloy was studied by wide-angle X-ray diffraction.
利用广角X射线衍射分析仪对低熔点金属及合金填充聚合物材料体系的结晶行为进行了研究。
X-ray diffraction patterns of two alloy systems have been measured.
测定了两种合金系箔材的X线衍射谱。
The defective cast blades blanks of K6 alloy are examined by means of optical, Scanning Electron Microscopy (SEM) and Energy Dispersive X-ray Spetrum (EDS).
应用金相显微镜和扫描电镜以及X射线能谱分析了K6合金铸造叶片的质量问题。
Their structure in a glassy state of all alloy tested has been confirmed by X-ray diffraction analysis.
所有合金玻璃体经X射线衍射分析证明为玻璃态结构。
Using electron microscopy and X-ray diffraction techniques, the structure changes of Fe-Cr-Al alloy being used at low temperature for a long time were investigated.
应用电子显微镜、X射线衍射技术,对低温长期使用的铁铬铝电热合金进行分析。
The results show that K40S alloy possesses high low cycle fatigue resistance in comparison with X-40 alloy.
结果表明:与传统X-40合金相比,K40S合金具有优异的抗高温低周疲劳性能;
Residual stress distribution for engine cylinder body made of casting aluminum alloy was investigated completely using X-Ray nondestructive detection method.
利用X射线无损检测方法,对铸造铝合金制造的某发动机汽缸体的残余应力分布进行了全面分析。
Methods 51 cases of large airway stenosis were treated with the self-expanding NiTi alloy stents through oral cavity (16cases) or nasal cavity (35 cases) under the guide of X-ray.
方法对51例大气道狭窄患者在透视下,其中经口16例,经鼻35例,应用支架放置器将镍钛合金支架放入狭窄的大气道。
The Tm- Fe alloy films obtained at room temperature are amorphous by x - ray diffraction (XRD).
射线衍射分析表明:室温下所得合金膜衍射峰是弥散的包峰,所得到的合金膜是非晶态的。
Manganese elements in low alloy steel, electrician steel, high manganese steel and stainless steel were measured with sequential wavelength scanning X-ray fluorescence spectrometry.
应用波长扫描X射线荧光光谱法对中低合金钢、电工钢、高锰钢、不锈钢中锰元素进行测定。
Properties of the Zn-Ni alloy deposit were determined with the methods of X-ray diffraction analysis, microhardness and salt -spray test.
采用X—射线衍射分析法、显微硬度测试法和盐雾试验法来检测镀层性能。
WANG K, YAN Z F, WANG W X, et al. Temperature evolution and fatigue properties prediction for high cycle fatigue of magnesium alloy[J]. Journal of materials Engineering, 2014, (1):85-89.
[28]王凯,闫志峰, 王文先, 等。循环载荷作用下镁合金温度演化及高周疲劳性能预测[J]。材料工程,2014,(1):85-89。
WANG K, YAN Z F, WANG W X, et al. Temperature evolution and fatigue properties prediction for high cycle fatigue of magnesium alloy[J]. Journal of materials Engineering, 2014, (1):85-89.
[28]王凯,闫志峰, 王文先, 等。循环载荷作用下镁合金温度演化及高周疲劳性能预测[J]。材料工程,2014,(1):85-89。
应用推荐