In this paper, a. new algorithm substituting an optimized round arc for the outline of tooth curve of an epicyclic gear tooth with long amplitude is discussed.
本文提出了用最优化圆弧代替长幅外摆线轮齿廓曲线的一种新型算法。
Based on basic theory of maximum error minimum method, double arc parameters for normal tooth outline in rectangle spline hob are optimized to obtain tooth outline in workpiece with minimum error.
根据最大误差最小法的基本原埋,对矩形花键滚刀法向齿形的双圆弧参数进行了优化,使滚刀加工出的工件齿形误差最小。
In this paper, the curvilinear equations of pin gear tooth outline are deduced by the differential geometry method, and the software for the dynamic design of pin gear transmission is designed.
文章采用微分几何的方法建立了销齿轮齿形的曲线方程,设计了销齿轮传动的动态设计软件。
According to principle of plane engagement, the paper deduces the equation of conjugate tooth outline in workpiece from given double-arc tooth outline of hob.
根据平面啮合原理,由给定的滚刀双圆弧齿形,推导出与其共轭的工件齿形方程。
With this method, the calculated points distribution of the tooth outline are uniform, thus the design accuracy is increased remarkably.
按照此法计算,可使滚刀齿廓上的计算点均匀分布,提高滚刀的设计精度。这种方法可应用于类似的刀具设计中。
The way to solve the problem of the tooth outline overlap interference caused by the processing errors in the practical use is put forward.
应用具体实例,研究了加工误差对少齿差内啮合齿廓重迭干涉的影响,并提出相应的解决方法。
The way to solve the problem of the tooth outline overlap interference caused by the processing errors in the practical use is put forward.
应用具体实例,研究了加工误差对少齿差内啮合齿廓重迭干涉的影响,并提出相应的解决方法。
应用推荐