IP address to assign to the network adapter.
要分配给网络适配器的IP地址。
How to: Configure a Network Adapter to Automatically Adjust Speed.
如何：将网络适配器配置为自动调整速度。
Your host has an active network adapter that can be used to send out the request.
您的主机有一个活跃的网络适配器，可以使用它发送请求。
To configure a network adapter on a server running AIX, perform the following steps.
要在运行AIX的服务器上配置网络适配器，请执行下列步骤。
Before beginning to configure the network adapter, first document the following information.
在开始配置网络适配器之前，首先记录下列信息。
Also, it is fairly common for a network adapter to be moved from one computer to another.
另外，它是相当常见的从一台计算机移动到另一个网络适配器。
Your computer's wireless hardware is a wireless access point, not a wireless network adapter.
计算机的无线网络硬件是无线访问点，不是无线网络适配器。
On the client computer, enable automatic detection of the link speed for the network adapter.
在客户端计算机上，启用对网络适配器链接速度的自动检测。
It is also called a network adapter. Its function is to adapt the host device to network medium.
它也被称为网络适配器，其功能是使主机适应网络介质。
This will prevent an IP address being configured on the physical network adapter used for the install.
这会防止在安装所用的物理网络适配器上配置IP地址。
The establishment of the network game, you need the PC network adapter and network data exchange.
在网络上建立游戏时，你的PC需要通过网络适配器与网络进行数据交换。
Select the network adapter you want to configure from the list shown in figure 1, and then click Enter.
从图1显示的列表中选择要配置的网络适配器，然后按enter。
The target host is running and has an active network adapter configured with the IP address that you used.
目标主机正在运行，而且在您使用的IP地址上配置了活跃的网络适配器。
To find values for these Settings, see your network adapter manual, or ask your system administrator.
要查找这些设置的值，请参阅网络适配器手册或洽询系统管理员。
Th network adapter cannot be used by the cluster because it is currently disconnected from the network.
网络适配器无法用于群集因为当前正与网络断开。
It USES the physical network adapter using the SEA just created to access the public network (see Listing 3).
它使用刚才创建的SEA，通过物理网络适配器来访问公共网络(请参见清单3)。
The network device is set up as part of a network team. You cannot run the test on this network adapter.
此网络设备已配置为网络的一个组成部分。不能在此网络适配器上进行检测。
To improve transfer and receive large amounts of data, you can configure a couple of network adapter Settings.
要改进数据的传输和接收，可以配置一些网络适配器设置。
OTG's experience with Gigabit Ethernet showed a gradual trend of network adapter performance degradation.
OTG使用千兆以太网的经验显示出网络适配器性能有逐渐退化的趋势。
As mentioned earlier, when setting up the network adapter, you typed the IP address location to a name server.
如前所述，在设置网络适配器时，您输入了名称服务器的IP地址。
One network adapter for the control node will suffice in low-traffic Settings, but two is better on busy networks.
控制节点使用一个网络适配器便足以满足低流量设置，但是对于繁忙的网络来说，有两个网络适配器更好。
Simply configure your network adapter, direct DNS to a valid DNS server, and you'll be surfing the Web in no time!
只需配置您的网络适配器，将DNS 指向有效的 DNS服务器，您立即就可以在网上冲浪！
Only one network adapter was found on the node. Add another network adapter to avoid a single point of failure.
在节点上只找到一个网络适配器。请添加另一个网络适配器以避免单一故障点。
The specified network adapter is not valid because it is a loopback adapter. Specify a different network adapter.
指定的网络适配器无效，因为这是一个环回适配器。请指定其他网络适配器。
CAN network adapter with low cost and steady performance has been made, and it will has bright foreground application.
设计制作的CAN网络适配器成本低，性能稳定，具有较好的应用前景。
Now that you've configured the network adapter and modified /etc/resolv.conf to your liking, you can test your Internet connection.
现在已经配置了网络适配器并根据您的喜好修改了 /etc/resolv.conf，接下来可以测试您的Internet连接。
To run this wizard at least one network adapter must be enabled. Enable an adapter in network Connections and then rerun the wizard.
必须至少启用一块网络适配器才能运行此向导。请在网络连接中启用适配器，然后重新运行此向导。
Look at your display or network adapter drivers. If you see "VMBus" in its name, you know that it is using the synthetic driver approach.
查看你的显卡和网卡适配器驱动，如果你看到它们的名字里有“VMBus”,使用的就是合成驱动的方法。
For each active network adapter, the transmit queue (tx_for Ethernet) and the receive queue size should be increased to their maximum value.
对于每个活动的网络适配器，传送队列(tx_forEthernet)和接收队列应该增加到它们的最大值。
For each active network adapter, the transmit queue (tx_for Ethernet) and the receive queue size should be increased to their maximum value.
对于每个活动的网络适配器，传送队列(tx_forEthernet)和接收队列应该增加到它们的最大值。
应用推荐