Then, the closed-loop control system model based on the ADRC is established.
建立了基于自抗扰控制器的双级矩阵变换器闭环控制系统模型。
Each control units is designed a digital closed loop control system using the fixed phase.
每一个传动单元都构成一个数字闭环控制系统。
Parameter perturbation bounds for robust stability of the closed loop control system are given.
给出了闭环控制系统保持大范围一致稳定时参数摄动应满足的限度。
It is also a good laboratory flat of feedback loop control system and nonlinear control system.
同时也是闭环和非线性控制研究很好的平台。
This paper presents the loop control system for high speed wire rod mill at Tangshan Iron and Steel co.
本文介绍唐钢高速线材轧机的活套控制系统。
The multi-channel closed loop control system is easily programmed to handle event as well as time dependencies.
多渠道的闭环控制系统是轻松编程处理活动，以及随着时间的依赖性。
The laser signal combined with a closed - loop control system can be used in automatic level flatting of the ground.
自准水平激光仪的激光信号与闭环控制系统的结合，实现地面的水平平整，它是自准水平激光仪的一种动态应用。
The model of speed loop control system as well as the integral separating PI controlled algorithm was analyzed in detail.
对控制系统建模和积分分离PI算法进行了详细的分析。
Information transmission between ground and down hole is the of key the closed-loop control system of wellbore trajectory.
地面与井下的信息传输是井眼轨道自动闭环控制的核心。
The laser flatting signal combined with a closed-loop control system can be used in automatic level flatting of the ground.
激光扫平信号与闭环控制系统结合，可实现地面的水平平整。
Economic evaluations show that the closed loop control system has a promise application prospect in boiler combustion optimization.
对若干电厂的经济性评估分析表明，闭环控制系统在电站锅炉燃烧优化中有很高的应用前景和推广价值。
A general introduction was made on effect, control principle and PLC logic control of the loop control system in high speed rod rolling.
概述活套控制系统在高速线材轧制中的作用、控制原理、PLC逻辑控制及活套调节对精轧机和夹送辊、吐丝机之间张力的影响。
Utilizing the linearity peculiarity of the exciting current of magnetic powder brake and brake moment, the closed loop control system is designed.
利用磁粉制动器的励磁电流与制动力矩成线性关系这一特性，设计了闭环张力控制系统。
The problems of dynamic response analysis of closed loop control system based on probability for the random intelligent truss structures are studied.
针对随机压电智能桁架结构研究了基于概率的结构闭环控制系统动力响应分析模型与方法。
Then, this thesis applies IP control algorithm to change controller in outer loop but not in inner loop based on basic double closed loop control system.
然后，本文在传统双闭环控制的基础上，内环的控制算法不变，改变外环控制器的设计算法，主要采用IP控制方案。
By theoretical analysis, the closed-loop control system is proved to be semi-globally uniformly ultimately bounded with tracking error converging to zero.
理论分析证明了闭环系统是半全局一致终结有界，且跟踪误差收敛到零。
The problems of dynamic response of closed loop control system for stochastic intelligent truss structures under stationary random excitation were studied.
研究平稳随机激励下随机智能桁架结构的闭环动力响应问题。
Adopting ac servo motor as a drive device, can and dc servo motor as a high precision, high performance and a half closed loop or closed loop control system.
采用交流伺服电机作为驱动器件，可以和直流伺服电机一样构成高精度，高性能的半闭环或闭环控制系统。
Based on the features of the injection molding machine, a new closed loop control system for main processing parameters has been realized with some software.
针对普通型注塑机特点，提出对控制系统增加控制软件，使注塑机的各主要工艺参数的液、机、电控制回路实现全闭环控制。
This paper introduced the measure and control principle of refrigerated container simulation chamber, analyzed the composing of the closed loop control system.
本论文介绍了冷藏集装箱环境室测控系统原理，分析了闭环控制系统的构成。
At last, simulations and experiments of the double-closed-loop control system of the motor are carried out and results of simulations and experiments are given.
最后，对两相混合式同步电动机的双闭环控制系统进行了仿真和实验，给出了仿真和实验结果。
Adopting ac servo motor as the driving device, can the dc servo motor and a high precision, high performance as the half closed loop or closed loop control system.
采用交流伺服电机作为驱动器件，可以和直流伺服电机一样构成高精度，高性能的半闭环或闭环控制系统。
This paper introduces an electrohydraulic control system based on PLC. A double close - loop control system with electro - hydraulic proportional valve is adopted.
一种基于PLC的电液自动控制系统，采用了电液比例阀的双闭环控制系统。
High accurate double channels rotary transformer is the position detecter of the launcher, feeding back the position information of the closed-loop control system.
采用高精度双通道旋转变压器作为发射架的位置检测装置，实现了闭环控制系统中位置信息的反馈。
Because the delayed effects exist in any closed - loop control system, it is more important and significant to study the stability of the control system with delay.
由于任何闭环控制系统都存在滞后效应，所以研究滞后型控制系统的绝对稳定性意义尤为重要。
The closed -loop control system of position, velocity, current using Limited Angle Brushless DC Torque Motor is designed and simulated and its reliability is designed.
完成了有限转角无刷直流力矩电机的位置、速度、电流闭环控制系统的设计和仿真，并完成了控制系统的可靠性设计。
The core of the closed-loop control system for the mirror tilting systems are displacement sensors which determine the exact positional values via the mirror movement.
为了实现对镜面倾斜角度的闭环控制，核心的问题是通过非接触位移传感器准确测量镜面角度。
The core of the closed-loop control system for the mirror tilting systems are displacement sensors which determine the exact positional values via the mirror movement.
为了实现对镜面倾斜角度的闭环控制，核心的问题是通过非接触位移传感器准确测量镜面角度。
应用推荐