• The system inlet temperature is greater than the upper critical threshold.

    系统进气孔温度高于上限临界阈值

    youdao

  • The effects of inlet temperature and inlet velocity were taken into account.

    实验考虑进气速度、进气温度贫油熄火油气比的影响

    youdao

  • Inlet temperature distortion is one of the key factors effecting engine stability.

    发动机进口温度畸变影响发动机稳定性关键因素之一

    youdao

  • Whereas, the heat transfer of turbulence liquid film flow is not sensitive to liquid film inlet temperature.

    湍流时,热量传递进口温度的反应不如层流敏感

    youdao

  • The article analyses the best inlet temperature of false twister in polyester distortion technique by examples.

    通过举例说明聚酯变形工艺最佳假捻入口温度

    youdao

  • The effects of the cooling water and freezing water inlet temperature are also predicted. The results are reasonable.

    对地下水源热泵机组的性能随着冷却水、冷冻入口水温变化情况做了预测结果合理。

    youdao

  • T he flow rate regulation range was too narrow, and the change of heat removing capacity depended on the change of inlet temperature.

    揭示了液体受管道结构等条件限制,合理调节范围较窄,服装温度比效率不会很高,应主要靠调节进口液温来改变服装的散热量

    youdao

  • The inlet temperature and internal temperature of exhaust catalyst for two stroke moped are tested under different vehicle driving speed.

    不同车速行驶工况行程轻便摩托车用尾气催化剂入口中心温度进行了测量与分析。

    youdao

  • The higher the normal load, the smaller the effect of the lubricating oil inlet temperature and rolling speed on the traction coefficient.

    随着载荷增大,入口温和滚动速度拖动系数影响减小

    youdao

  • The measures to solve these problems in heating transport with PPD and lowering the mini - mum inlet temperature for Daqing Oil are proposed.

    提出了降凝剂进行热处理输送适当降低规程中的大庆原油最低进站温度改进措施

    youdao

  • For rolling dryer, the higher filling power value corresponds to downstream quickly drying way, higher inlet temperature and moisture content.

    对于转筒式丝机,采用顺流方式较高来料温度水分,较大的热风流速,可获得较高的烘丝填充

    youdao

  • Increasing overall flow velocity and depressing the inlet temperature of cooling water has little effect on improving temperature distribution.

    提高冷却水流速降低进口温度电池内温度分布改善作用不好。

    youdao

  • The performance of gas turbine has relation with the environmental temperature, and its output is reduced with increase of gas inlet temperature.

    燃气轮机性能环境温度有关,出力随空气进气温度升高而降低,燃气轮机进气冷却增加出力最有效的方法。

    youdao

  • Unit energy consumption of the extruder decreases as the speed increases, but raises with the pressure, inlet temperature, plastics segment increased.

    挤出整机单随着转速增加降低随着压力进料口温度塑化温度增加而上升。

    youdao

  • An effective method for maintaining the vacuum in condenser is to change the flow rate of circulating water according to its different inlet temperature.

    不同循环水进口温度条件下,合理改变循环水流量维持凝汽器真空有效办法

    youdao

  • Cooling towers' influence on the inlet temperature of circulating water was also considered to determine optimum running mode of circulating water pumps.

    同时考虑闭式循环水系统中冷却塔循环水入口温度影响确定循环水泵运行方式

    youdao

  • This paper discusses the effect of compressor inlet temperature on its performance, thereby puts forward some measures to keep the inlet temperature constant.

    本文分析压气机性能试验压气机进口温度变化性能的影响提出保持进口恒温一些措施

    youdao

  • With the increase of the turbine inlet temperature of high performance aero-engine day by day, the turbine coating blade coating technology has been widely used.

    随着高性能航空发动机涡轮进口温度日益提高涂层技术涡轮叶片上得以广泛应用。

    youdao

  • In this article, the main influencing factors on condensation heat transfer include air flow rate, coolant flow rate, coolant inlet temperature and mixed gas velocity.

    课题中影响传热过程因素主要空气含量、冷却水流量、冷却水温度混合气

    youdao

  • The influences of the Angle of tilt and the inlet temperature and concentration and the absorption pressure on the performance of heat and mass transfer are discussed.

    讨论了斜板尺寸进口温度浓度吸收压力等参数对传热性能影响

    youdao

  • Higher gas inlet temperature, lower steam pressure or pinch point temperature difference lead to lower exhaust gas temperature, larger evaporation and higher efficiency;

    提高进口烟气温度降低蒸汽压力减小节点温差,均可显著降低设计出口烟气温度,从而增大蒸发量,提高热效率;

    youdao

  • The experimental results show that in the process of flow excursion the mass flow rate and the inlet temperature decreases, while the exit temperature increases smoothly.

    研究结果表明发生静态流量漂移时,系统循环流量下降、加热段进口温度下降出口温度上升;

    youdao

  • Table 1 contains the recommended temperature that the heatsink base test point or the air inlet temperature should remain below during the thermal evaluation of a system.

    1含有进行系统热量测量时散热器基座测试空气入口温度应该低于推荐温度值

    youdao

  • Properly increasing the furnace inlet temperature, strengthening the process management and selection of aluminum diffused plates could effectively protect the corrosion.

    适当提高尾气入口温度加强工艺管理采用渗铝板进行包补防止腐蚀的有效措施

    youdao

  • Based on the heat exchange theory between air and rock, the feasibility of decreasing air inlet temperature by temperature regulating action of shallow ground is discussed.

    根据空气岩体热交换原理探讨了利用浅部地层调温作用降低深井入温度可行性

    youdao

  • It can be seen that if the engine air inlet temperature is higher and the ambient pressure is lower than the standard conditions, the power output of the effects will be lower.

    可以看出如果发动机进气温度较高环境压力低于标准条件下输出功率影响降低

    youdao

  • Based on the research on the heat exchange regularity between air and rock in air-inlet temperature-regulating system, a new method for improving mine ventilation is presented.

    通过研究矿井风调温系统空气岩体热交换规律,提出了改善矿井通风一种方法

    youdao

  • A first order lagging equation is used to acount for dynamic effects. This model can simulate the compressor response to inlet temperature transients and find the critical stage.

    模型可以模拟进口温度(或压力)变下压气机的逐级响应寻找首先失速关键

    youdao

  • A first order lagging equation is used to acount for dynamic effects. This model can simulate the compressor response to inlet temperature transients and find the critical stage.

    模型可以模拟进口温度(或压力)变下压气机的逐级响应寻找首先失速关键

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定