They are thermal expansion, vaporization and dielectric breakdown.
它们是热膨胀、汽化和介质击穿。
A physical model of dielectric breakdown was presented in IC silicon dioxide films.
提出了芯片门电路硅氧化层静电放电介质击穿的物理模型。
Dielectric breakdown of BST thin films prepared by RF sputtering is studied in this paper.
采用射频溅射制备BST薄膜，研究了薄膜的介电击穿特性。
The time dependent dielectric breakdown of tunneling oxide used for EEPROM's is investigated.
阐述了应用于EEPROM中的超薄隧道氧化层随时间的击穿特性。
TDDB(time-dependent dielectric breakdown)is a key method to value the quality of thin gate oxide.
经时绝缘击穿（TDDB）是评价薄栅氧化层质量的重要方法。
And proper content of nano-Al2O3 could improve dielectric breakdown strength of these composites.
适量纳米Al2O3可以提高材料的电击穿强度。
A state monitoring method of power cable based on the analysis of dielectric breakdown characteristic was presented.
在对绝缘介质击穿特性分析的基础上提出了一种电力电缆状态监测方法。
The short-pulsed liquid dielectric breakdown characteristic is the basis of the application of pulse-power technique.
快脉冲下液体绝缘介质击穿特性是脉冲功率技术应用的基础。
The time to dielectric breakdown under magnetic field depended on the relative Angle between magnetic field and sample surface.
磁场环境下的绝缘破坏时间依赖于磁力线与试样表面的相对夹角。
The process of dielectric breakdown in uneven electric field is analyzed and the influence of electrode polarity on gap breakdown is researched.
文中分析了在极不均匀电场下间隙的击穿过程，并用试验研究了微细加工时电极极性对间隙击穿电压的影响。
Test method for ASTM D149 solid electrical insulating materials at commercial power frequencies the dielectric breakdown voltage and dielectric strength.
ASTM D149固体电绝缘材料在工业电源频率下的介电击穿电压和介电强度的试验方法。
Standard Test Method for dielectric breakdown voltage and dielectric strength of D149 ASTM solid electrical insulating materials at industrial power frequencies.
ASTM D149固体电绝缘材料在工业电源频率下的介电击穿电压和介电强度的试验方法。
The exact determination of the breakdown voltage must therefore be attached to the measurement of an electrical value characteristic of the dielectric breakdown phenomenon.
因此击穿电压的检测必须重视电介质击穿现象的电参数值的测量。
According to the main factors for the main factors for the dielectric breakdown, this article presents the capacity index problem for the alternating current pressurization breakdown equipment.
根据影响介质击穿的主要因素，阐述了交流耐压击穿装置的容量指标问题。
The cord set completed required cycles of flexing with no occurrence of end results and also successfully completed the Dielectric Strength Test without breakdown.
插头完成了要求的弯曲周期，没有出现上文所提到的最后结果，并且通过了电绝缘强度测试，没有损坏。
On the basis of the trap theory of polymer breakdown by authors, the dielectric strength is the function of the trap density, which has been demonstrated in electrical ageing of polymer.
在聚合物电老化击穿的陷阱理论中，介电强度与陷阱密度呈函数关系，这已在电老化试样上得到证实。
Breakdown property is the basis requirement to dielectric and the improvement of the electrical strength is one of the most important works in dielectric research field.
击穿性能是电介质材料最基本的要求，提高材料的电气强度是电介质研究最为重要的任务之一。
Insulating Oil Testers is a kind of effective tool for testing the dielectric oil breakdown voltage in power field.
绝缘油击穿电压测试仪就是电力系统中测试绝缘油耐压强度的测试仪器。
Water dielectric, because of its great dielectric constant and high breakdown stress, is extensively used as the energy storage medium in high power pulse conditioning system.
水介质由于具有介电常数大和击穿场强较高的特点，普遍应用于高功率脉冲调制器作中间储能介质。
The result showed that burying sintering process may make breakdown voltage smaller and apparent dielectric constant bigger.
结果表明，采取粉料埋烧可以明显降低压敏电压、提高介电常数。
On the other hand, the main problems for the application of CCTO are its high dielectric loss, low breakdown voltage and compatively small I-V nonlinear coefficient.
此外，其较大的介电损耗、较低的压敏电压以及较小的宏观I-V非线性系数限制了其实用化。
Cable insulation fault occurs frequently. Its location is complicated especially when the dielectric strength between two adjacent cores becomes low (incomplete breakdown).
绝缘故障是线缆的常见故障之一，当两个绝缘线芯之间处于低绝缘(或不完全击穿)条件下其定位技术更为复杂。
TGA and High voltage Bridge are used to test the dielectric loss factor and the breakdown voltage of the solvent-free insulating varnish.
用TGA、高压电桥等测试了无溶剂绝缘漆的介电损耗因子、介电强度等绝缘性能。
TGA and High voltage Bridge are used to test the dielectric loss factor and the breakdown voltage of the solvent-free insulating varnish.
用TGA、高压电桥等测试了无溶剂绝缘漆的介电损耗因子、介电强度等绝缘性能。
应用推荐