The parameterized design about the C8051 micro controller IP soft core is studied.
研究了C8051微控制器IP软核的参数化设计。
The PCI Bus Controller IP is part of the IP library of Aviation Microelectronic Center.
该文介绍的PCI目标设备总线控制器的IP设计就是航空微电子中心建库工作的组成部分。
Set the IP address of each controller using the serial port at the back of each enclosure.
使用每个封装背面的串行口设置每个控制器的IP地址。
If a specific domain controller is referenced by it's IP or DNS requests will only handled by this single host.
如果用ip或dns引用特定的域控制器，请求就只由这个主机处理。
The client system's DNS server value is set as the domain controller address in the TCP/IP Properties window as shown in figure 8.
在图 8所示的TCP/IPProperties窗口中，客户端系统的DNS服务器值被设置为域控制器地址。
Updating the Baseboard Management Controller (BMC) firmware and setting an IP address.
更新基板管理控制器(BMC)固件和设置IP地址。
Use the command netCfgShow to show the current IP settings of the controller, and use the command netCfgSet to set the desired IP address, subnet mask, and gateway.
使用命令 netCfgShow显示控制器的当前IP地址设置，使用命令netCfgSet 来设置所需连接的 IP 地址、子网掩码和网关。
Then, this thesis applies IP control algorithm to change controller in outer loop but not in inner loop based on basic double closed loop control system.
然后，本文在传统双闭环控制的基础上，内环的控制算法不变，改变外环控制器的设计算法，主要采用IP控制方案。
P-IP controller structure and method of determining parameter were analyzed in detail.
详细分析了P-IP控制器的结构和参数确定方法。
This thesis introduces the design of USB2.0 IP CORE for USB device controller, and mainly about the design of the main controller of the IP CORE.
本文介绍一种USB2.0设备控制芯片IP核的设计，并且主要对其中的主控制器的设计进行介绍。
Finally, a high performance PMLSM speed servo system is designed with IP speed controller.
最后，结合IP速度控制器设计了一高性能永磁直线同步电机速度伺服系统。
The IP controller, which has the ability of rapid response, is applied to satisfy the rapid performance.
利用IP速度控制器的快速反应能力来保证系统的快速性，共同实现系统的性能指标。
A new method of IP robust controller design for NC machine tool droved by linear servo system was presented based on robust control theory.
对数控机床直线伺服系统IP控制器提出用鲁棒控制理论进行设计的新方法。
A new method of IP robust controller design for NC machine tool droved by linear servo system was presented based on robust control theory.
对数控机床直线伺服系统IP控制器提出用鲁棒控制理论进行设计的新方法。
应用推荐