结论由于偏心负载,股骨转子下区可以产生很高的弯曲负荷。
Conclusion There are higher bending loads at the subtrochanteric area of the femur due to the eccentric loading.
泵工作时,由于两从动螺杆与主动螺杆左右对称啮合,故作用在主动螺杆上的径向力完全平衡,主动螺杆不承受弯曲负荷。
Pumps work, as the two screws driven screw symmetrical and active engagement, so the role of the active radial force on the screw entirely balanced, active screw does not bear bending loads.
通过大量的雷电冲击放电试验、工频电弧试验和弯曲负荷试验等试验研究,研制出了一种放电箝位柱式复合绝缘子和配套的绝缘罩。
By means of lots of lightning impulse tests, power frequency arc tests as well as bend loading tests, a kind of clamping post composite insulators with matching insulation hoods is developed.
在冲击负荷下,最大负荷超过了轧辊芯部材料所能承受的最大抗弯曲负荷,发生截面断裂。断裂一般产生于负荷应力为最大的截面。
Under shock load conditions the peak load can exceed the ultimate bending strength of the core material and fracture occurs, usually at the most highly stressed cross section area.
开口朝向良好,有合理的方形比例,不使内部表面的弯曲超出负荷。
The opening are well orientated, with sober rectangular proportions which do not overload the curve of the internal facades.
骨盆目的是加强而不是弯曲载荷下断裂,从而保持持续的负荷曲线。
The pelvic bolster is designed to bend but not fracture under load, thus maintaining a continuous loading curve.
在不规则样条的负荷-挠度取拐点后直线段切线与横坐标的交点作零点修正后所测得的弯曲弹性模量比较接近真实值。
Drawing a tangent after inflection and intersected the abscissa the slope of the tangent was taken as the flexile modulus.
分析在不同预负荷时弯曲过程中温度、应力、残余应力的分布和弯曲角度对于变形机制的影响。
The influences of bucking mechanism caused by distribution of temperature, stress, residual stress and bucking angle are analyzed with different preloads.
使轴承上的径向负荷不对轴造成相对弯曲。
No inclination of shaft relative to the will be caused by the radial load acting on the bearing.
使轴承上的径向负荷不对轴造成相对弯曲。
No inclination of shaft relative to the will be caused by the radial load acting on the bearing.
应用推荐