Because of this I simply want to cancel the orders manually in the database and skip the standard void process.
我只是想取消订单手动在数据库和跳过标准无效的程序。
Void emergence was an inevitable result of superplastic deformation. It affected the process of grain rearrangement directly.
结果表明，空洞的形成直接影响着晶粒重排过程。
The differences of solid liquid phase change heat transfer process between two different void positions are analyzed through numerical simulation.
通过数值模拟计算，分析了两种不同的空穴位置下固液相变换热过程的差别。
The acquired typical void fraction signal is presented and qualitative discussion to the dynamic process and mechanism of flow is hence delivered.
定性讨论了不同流型下典型动态时序信号的差别与相应的流动现象与机理。
And some problems that should be noticed in the assembling process of RF cable assemblies, and the possible problem of inter conductor void-welding are also discussed.
探讨了在组装过程中应注意的问题，以及针对内导体焊接易出现虚焊问题进行研究。
The void enlarges heat resistance, and then affects the phase change heat transfer process.
空穴的存在增大了热阻，从而影响相变换热过程。
In this paper a model for the whole process of soil compacted by dynamic compaction is proposed and the problems of two ultimate void ratios are discussed.
提出一个强夯中土体被夯实的全过程模型，讨论了两个极限孔隙比问题。
The results show that the crack is formed by acting of center void and intergranular cracks. Some technic modifcation of the smelting process is raise to prevent nucleation of the cracks.
经检验分析认为这种裂纹是缩孔与晶间裂纹的结合体，并提出了一些解决方法。
The new soldering process with low void ratio, high efficiency and high quality conformance can be used in the soldering of high reliability power electronics.
采用新焊接方法得到的试样空洞率低、焊接效率高、质量一致性好，可用于高可靠性功率电子产品中。
To simulate wire drawing process conditions of consumers, the ER70S-6 high speed wire rod for welding wire, which is rolled with shrinkage void square billet at center, is drawn.
模拟用户的拉丝工艺条件，对中心缩孔方坯轧制的ER70S - 6焊丝用高线盘条进行拉拔试验。
To simulate wire drawing process conditions of consumers, the ER70S-6 high speed wire rod for welding wire, which is rolled with shrinkage void square billet at center, is drawn.
模拟用户的拉丝工艺条件，对中心缩孔方坯轧制的ER70S - 6焊丝用高线盘条进行拉拔试验。
应用推荐