The timing synchronization algorithm of training symbols for the OFDM systems is an old timing algorithm.
OFDM系统的训练符号定时同步算法是一种传统的定时算法。
A symbol timing algorithm for orthogonal frequency division multiplexing (OFDM) systems with the cyclic prefix under wireless channels is proposed.
提出了一种新的无线信道下基于循环前缀的正交频分复用系统符号定时同步算法。
This paper presents the implement of the all-digital symbol timing recovery using the DTTL Algorithm over 8psk demodulation system.
本文阐述了DTTL全数字符号定时恢复算法在8psk解调系统中的实现。
Firstly, false paths in static timing analysis and the algorithm to sensitize paths are presented, and then some factors affecting gates and interconnects delay are discussed.
首先，文章讨论了静态时序分析中的伪路径问题以及路径敏化算法，分析了影响逻辑门和互连线延时的因素。
Study shows the simplified implementation scheme is applicable in hardware implementation of MIMO-OFDM system timing synchronization algorithm.
研究表明，简化实现方案可以用于MIMO - OFDM系统定时同步算法的硬件实现。
This paper describes a novel joint acquisition algorithm of timing and carrier frequency for burst orthogonal frequency division multiplexing (OFDM) transmission system.
提出了一种新的正交频分多路（OFDM）传输系统定时和载波频率捕获联合算法。
A data aided symbol timing estimation algorithm was proposed for burst-mode space-time trellis coded multi-level continuous phase modulation (STTC-MCPM) systems in Rayleigh fading channels.
针对瑞利衰落信道中突发模式的空时网格编码的多电平连续相位调制(STTC - MCPM)系统，提出了一种基于数据辅助的符号定时估计算法。
This algorithm utilizes inherent correlation property of two segments of information sequence to carry out accurate symbol timing estimation.
该算法利用经过特殊处理的前后两段信息序列的内在相关性进行准确的符号定时估计。
Various existing synchronization algorithm to estimate symbol timing offset and carrier frequency offset can be classified into blind and pilot-aided methods and algorithm based on cyclic prefix.
目前，估计载波频率偏差和符号定时偏差的算法主要有数据辅助的方法和非数据辅助的方法以及基于循环前缀的算法。
Traditionally, the MLE algorithm is an effective method of symbol timing estimation, but it has very high computational complexity.
传统的MLE算法虽对符号定时估计很有效，但计算复杂度较高。
Traditionally, the MLE algorithm is an effective method of symbol timing estimation, but it has very low performance when there is ISI.
传统的MLE算法虽对符号定时估计很有效，但在ISI干扰情况下性能不高。
In this algorithm, the digital differential filtering (DDF) is used to process the sampled signals, the timing component of signal is improved, and therefore the convergence speed is quickened.
该方法用数字差分滤波对采样信号进行处理，提高了信号中的定时分量，从而加快了算法的收敛速度。
In this paper a timing synchronization algorithm using the geometry character of synchronization metric is presented.
提出了一种利用帧同步度量的几何特性进行统计判决的高性能帧同步算法。
This paper studies the changing process and presents the on - line algorithm of signal timing of intersection under guidance information.
文章对这一变化过程进行了研究，并提出诱导后的交叉口信号配时在线算法。
This paper investigated the timing and frequency offset estimation algorithm of OFDM burst transmission systems.
本文研究OFDM分组传输系统的符号同步与频偏估计算法。
Secondly, the timing synchronization algorithm for OFDM systems and frequency synchronization algorithm were researched.
其次对OFDM系统的定时同步算法和载波频率同步算法进行研究。
Although the computational complexity of the improved MC algorithm is lower than MLE algorithm, the timing estimation performance of MC algorithm greatly degrades.
而经改进的MC算法计算复杂度虽降低了，但其估计性能却大大下降。
Through adopting this algorithm the timing error is shortened to a half of the sample time interval.
通过采用这种算法可将定时误差缩小到只有抽样时间间隔的一半。
It always is a major project in the study of ICT to improve the timing performance of reconstruction algorithm without degradation in image quality.
因此，如何在保证图像质量的前提下，提高算法的重建速度一直是工业CT应用研究中的一个重要问题。
Experimental results show that the algorithm can optimize the timing of circuit efficiently and the timing constraint is satisfied.
工业测试实例实验表明，该算法能够有效地优化电路时延，满足时延约束。
In this paper, a novel symbol timing estimation algorithm is presented which realizes symbol synchronization by using a symbol.
本文提出了一种低复杂度的符号定时估计，利用一个训练帧来实现同步。
A new blind symbol timing-tracking algorithm is proposed, using the special OFDM frame structure with cyclic prefix and cyclic postfix.
利用具有循环前缀和循环后缀的OFDM帧结构，该文提出了一种新的符号定时跟踪盲估计算法。
The maximum mean power estimation timing recovery algorithm and the maximum-likelihood carrier phase estimation algorithm are employed.
采用了最大平均功率定时同步算法和最大似然载波相位估计算法。
Based on the statistical properties of LDPC decoding algorithm, a new timing error recovery algorithm is presented.
根据LDPC码译码算法的统计特性，提出了一种新的符号同步误差校正算法。
A new clock skew scheduling algorithm is proposed. This algorithm generates timing constraints which can effectively promote the area optimization of logic syn thesis.
提出了一种新的时钟偏斜规划算法，该算法所生成的时序约束可以有效地促进逻辑综合工具的面积优化。
The timing curve of this algorithm will present a spike pulse only at the right time, the resolution is greatly enhanced, so the symbol timing will be more accurate.
该算法的定时尺度曲线仅在正确定时点处出现一个尖峰，大大提高了分辨率，从而可以更加准确的进行符号同步。
This paper studies the changing process and presents the on - line algorithm of signal timing of intersection under guidance...
文章对这一变化过程进行了研究，并提出诱导后的交叉口信号配时在线算法。
An algorithm is described for timing drivem initial placement of building block layout, along with its realization.
本文着重研究了在初始布局阶段考虑系统时延特性的任意元胞的初始布局算法。
An algorithm is described for timing drivem initial placement of building block layout, along with its realization.
本文着重研究了在初始布局阶段考虑系统时延特性的任意元胞的初始布局算法。
应用推荐