• Next mold will be made from high tear strength RTV for sure.

    模具明年作出撕裂强度室温硫化肯定的。

    danci.911cha.com

  • For instance, 300%modulus was increased by 77% and tear strength by 38%.

    例如,300%定应力提高了77%,抗撕裂强度提高了38%。

    epub.cnki.net

  • Consider the bursting strength that is required and the tear strength desired.

    考虑爆破强度必需的,所需撕裂强度。

    www.futaiys.cn

  • The introduction of OR into SBR and NR enhanced their hardness and tear strength .

    纳米累托石加入可以显著提高SBRNR的硬度撕裂强度

    danci.911cha.com

  • Silicone tubing has some limitations, including lower tear strength when compared with PU tubing.

    硅胶一些限制包括降低撕裂强度相比PU管。

    www.chinasilicon.net

  • In this paper, research on curing system of vulcanized silicone rubber aging tear strength after impact.

    本文主要研究论述硫化体系硫化硅橡胶老化撕裂强度影响

    danci.911cha.org

  • It has a very high tear strength, high abrasion resistance and is extremely resistant to oils and greases.

    有着撕扯性,高耐磨性非常好的抗油性

    danci.911cha.org

  • The cause leading to deviation of tear strength in measuring tear strength of silicone rubber vulcanizate was analyzed.

    分析了在热硫化硅橡胶混炼胶撕裂强度测试撕裂强度出现偏差原因

    www.ilib.cn

  • Tear strength: it is the force required to tear a paper at a precut edge to a specific length and measured in milli-newton.

    撕裂度:一张事先切一小口,撕开一定长度所需,以毫牛顿计算

    www.websaru.net

  • It is mainly used as rubber reinforcement and filler, to improve their elongation, tear strength and resistance to abrasion.

    主要用作橡胶制品的补强剂填充剂明显改善橡胶制品的抗拉强度抗撕裂性和耐磨性

    danci.911cha.org

  • LDPE (Low Density Polyethylene) : Offers such advantage as tear strength and high chemical resistance. It is also waterproof.

    (密度聚乙烯):具有以下优良性质:撕裂强度,高耐化学性水性。

    www.dmcaraudio.com

  • It has a better flex cracking resistance than those of natural rubber but a lower tear strength and a higher dynamic modulus.

    天然橡胶具有较好的抗挠曲开裂性能撕裂强度较低动态模量较高

    www.infopetro.com.cn

  • LDPE (Low Density Polyethylene) : Offers such advantage as tear strength and high chemical resistance. It is also waterproof.

    LDPE(密度聚乙烯):具有以下优良性质:撕裂强度,高化学性,水性。

    www.dmcaraudio.com

  • The results showed that the tensile strength, elongation at break and tear strength increased with the OMMT content increasing.

    测试结果表明随着脱土用量的增加,复合材料的定应力、拉伸强度撕裂强度均大幅度提高。

    www.chemyq.com

  • The results showed that the filling of short fiber evidently improved tear strength, modulus at 10%and Shore A hardness of SFRC.

    结果表明纤维加入显著提高了SFRC撕裂强度、10%定伸应力邵尔A型硬度

    dict.cnki.net

  • The tensile strength, elongation at break and tear strength of TAIC were higher than those of PDM while the compression set was opposited.

    随着硫化助剂用量增加,TAIC共混胶拉伸强度、拉断伸长率撕裂强度大于PDM共混胶,压缩永久变形的变化率正好相反。

    lib.cqvip.com

  • There lie some correlations among mechanical properties. In this paper, we will take tear strength for example to discuss this correlation.

    物理性能参数存在着相互关系,该文撕裂强度其进行探讨。

    www.chemyq.com

  • The results showed that when compared with SBR, the NBR filled with calmos CC had higher tensile strength and tear strength, but lower curing speed.

    结果表明随着白燕华CC用量的增大,胶料表现出填充非极性SBR更高拉伸强度撕裂强度,硫化速度却明显减慢。

    dict.cnki.net

  • The mechanical experimental results showed that PVA had a little effect on the tensile strength, right Angle tear strength and elongation at break, and...

    力学性能测试结果表明,加pva的PE防雾膜拉伸强度直角撕裂强度,断裂伸长率等方面比未加PVA的防雾膜要,但不影响使用性能。

    www.chemyq.com

  • Methods: the water sorption, the water solubility and the tear strength of two kinds of silicon rubbers were examined and evaluated under the same conditions.

    方法:在相同条件下硅橡胶材料进行吸水率、溶解撕裂强度测定,对其进行t检验分析。

    www.chemyq.com

  • The silicon and fluorine rubber with high temperature resistance, low compression permanent deformation, and high tear strength properties can meet the water sealing gasket requirements.

    采用高温压缩永久变形、高抗撕裂橡胶可以满足部位需耐高温、耐冷却水的要求。

    dict.cnki.net

  • The results show that the presence of carbon fiber obviously enhances the hardness, heat resistance and oil resistance of the composite, but decreases the tear strength of the composite.

    结果表明纤维加入能提高橡胶硬度耐热油性,橡胶的扯断强度有所下降

    dict.cnki.net

  • Hydrolysis: Water and high temperature can change the consistency of certain polyurethanes. Colours change and material crumbles into small pieces. Tensile and tear strength deteriorate.

    水解很高温度可以改变一定聚氨酯类韧性颜色改变和原料分成张力会破坏

    www.jpnkyowa.com.cn

  • It was shown that MLPB could improve the interface combination between the organic fillers and the rubber matrix, and could increase the tear strength and the stickiness of the IIR rubbers.

    研究表明MLPB在一定程度上提高有机填料橡胶基体之间界面结合强度;同时,能有效地提高IIR胶料粘性能撕裂强度等性能指标。

    dict.cnki.net

  • The influence of the level of the pretreated short fibre on tensile strength, tear strength, flex fatigue and conductivity of the acetylene black filled VMQ/EPDM blend vulcanizate was studied.

    研究预处理纤维用量乙炔炭黑填充甲基乙烯基硅橡胶VMQ)/EPDM共混硫化拉伸撕裂、耐屈挠疲劳导电性能影响

    www.dictall.com

  • The tensile strength and tear of aramid paper that papermarking for two is strong than the aramid paper which is papermarking for one.

    分层抄造芳纶原纸次抄造芳纶原纸的强度撕裂度高;

    www.lwgsw.com

  • The experimental results show that when the matching between Aramid fiber and PPTA is 1:1.5 more or less, the tensile strength, tear and formation of aramid paper is the best.

    实验结果表明芳纶短切纤维芳纶浆粕配比为1:1.5左右时,所抄造纸页强度撕裂度、匀度最好

    www.lwgsw.com

  • Tatar tear out four, according to Hulunbeier grassland, increase in strength.

    塔塔儿部,呼伦贝尔草原,实力大增。

    www.youdict.com

  • Bulk density of small materials, heat conduction tear your eyes coefficient is generally small, but at the same time decreases in the mechanical strength, so be reasonable choice.

    容重材料一般导热盈眶系数小,同时机械强度也随之降低合理选择。

    www.jmhbjn.com.cn

  • Bulk density of small materials, heat conduction tear your eyes coefficient is generally small, but at the same time decreases in the mechanical strength, so be reasonable choice.

    容重材料一般导热盈眶系数小,同时机械强度也随之降低合理选择。

    www.jmhbjn.com.cn

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定