Pass the test, the basic realization of the integrated management books, online ordering and other functions into one book sales management system.
通过测试，基本实现了这个集成书籍管理、网上定购等功能于一体的图书销售管理系统。
A test system of precision machining based on virtual instrument is introduced. The theory of this test system and realization of hardware and software are discussed.
文章提出了一种基于虚拟仪器技术的精密加工测试系统，并讨论了这种测试系统的原理以及硬件和软件的实现。
Through study of the testing technique for oil feed circuit and designing principle of data fusion, the realization of fault test and diagnosis for hydraulic system was illustrated.
通过对液压系统供油回路的信号测试过程及信息融合方案的设计分析，阐明了液压系统故障检测和诊断的实现过程。
This paper introduces the principle of waveguide microwave leak test system, illustrates the formation and the realization of amplitude measurement unit and display-control unit in detail.
介绍了波导微波泄漏检测系统的原理，并对其中的幅度测量单元、显控单元的组成和实现作了详细的阐述。
The techniques used to improve the reliability of the controller are explained in detail, and the formation and realization of BIT (Built In Test) system are presented.
介绍了控制器设计中采用的可靠性保障措施和机内自检测系统的构成与实现方案。
Finally, it provides the reliable design methods, the detailed realization scheme and some test results for one geospatial information mobile service system.
提出了一种具有创新性的移动空间信息服务系统主体设计方案及具体实现策略，并给出了部分实验结果。
The paper introduced a test method of SCR device inner resistor, it is realization by use of microcomputer, and the composition of the test system.
介绍了一种晶闸管整流装置内阻的测试方法，测试系统的组成，以及微机实现技术。
In the article, the structure of the system's hardware and software modules are discussed, which explains the realization of the test system functions in detail.
本文介绍了系统的硬件结构和软件模块，详细阐述了测试系统功能的实现。
Then we discuss the composition, the principles and the realization ways of the distributional CAN bus-based monitoring system for the sequential turbocharging diesel engine test bed.
然后论述了基于CAN总线的相继增压柴油机试验台分布式监控系统的组成、原理及实现方式。
This paper discussed the principles of digital if and the realization on FPGA, and the test results were given to verify the performance of the system.
本文详细讨论了数字中频的原理以及在FPGA上的实现，最后给出了测试结果，验证了系统的性能。
This article introduced the author's idea and experience in the process of design industry temperature test system, illustrates the communication protocol design and the source code of realization.
该文介绍了笔者在开发工业温度检测系统的一些设计思想和体会，给出通信协议的设计和协议的源代码实现。
The paper describes the research on an automated test system based on virtual instrument for the TACAN navigation airborne equipment and its realization.
本文论述了一种基于虚拟仪器的塔康导航机载设备自动测试系统的研究与实现方法。
Followed, illustrates design, realization and test of system in detail; Finally gives summary of system.
接下来详细地阐述了系统的设计、实现以及测试，并进行了总结。
The article main elaboration level elementary knowledge, introduced the level usage, and finally is given a fluctuation layer realization method to solve an online test system.
主要论述层的基本知识，介绍了层的用法，并在最后给出用层来解决一个考试系统的浮动层的实现方法。
The design and realization of a simple low-cost laboratory test system are reported. The relationship of design parameter to emulation accuracy is analyzed. And the design principles are given.
在实验室条件下设计并实现了一种简单有效的测试系统，并分析了系统参数对测试精度的影响，给出了设计原则。
At the end, this paper gives the result of operation of this system, and carries out the pressure test and analysis for the realization of this application server system.
最后，论文给出了原型系统的运行结果，并对所实现的应用服务器系统进行了压力性能测试及分析。
Designation principles and realization ways of a real radio frequency identification system are also given in this paper. A test has been carried out and the expected efficiency has been achieved.
文中给出了一个实际的射频识别系统设计原则与实现方法，进行了实验并取得了预期的效果。
This system can acquire, store, process and plot for measured data of gear's each tooth which lays the foundation for the realization of automation in gear accurate test.
该系统可对齿轮每齿高的测量数据进行采集、存储、处理、并绘制成图，为最终实现齿轮精度测试的自动化奠定了基础。
This system union software engineering development theory, has carried on the demand analysis, the design, the realization and the test.
本系统结合软件工程的开发理论，进行了需求分析，设计，实现和测试。
The realization and test of this system are implemented and the test result shows the computation time meets the demand for real-time traffic control.
对系统进行实现与测试，结果表明系统运算时间符合实时交通控制需求。
The problems should be paid attention to while designing and manufacturing of the test system are introduced, and the realization method of the software and hardware of the system is given.
介绍了试验台机械设计制造中应注意的问题，给出了测试系统的软件、硬件实现方法。
The CTCS3 simulation and test platform is established thus far and provides foundations for perfection of system and realization of test functions.
CTCS 3级列控系统仿真测试平台到现在为止已经基本搭建起来，为今后的系统完善以及测试功能的实现提供了基础。
This paper introduces the principle and architecture of bus test-bed distributed control system, and mainly discusses communication principle and realization method between control-block.
分析了汽车封闭试验台分布式控制系统的基本原理及系统总体结构，详细讨论了试验台控制系统各控制模块之间的通信原理及其实现方法。
Intellectual test paper composition algorithm is the key in the design and realization of intellectual test paper composition system.
智能组卷算法是设计和实现一个智能组卷系统的关键。
Performance of the system is always very important, in the processes of system design, realization and test.
在系统设计、实现与测试的过程中，对性能方面的考虑尤为重要。
Performance of the system is always very important, in the processes of system design, realization and test.
在系统设计、实现与测试的过程中，对性能方面的考虑尤为重要。
应用推荐