By using a complete engineering example, this paper gives the data of static load test and the data of settlement observation of treated single pile and single pile complex foundation respectively.
文章介绍了一个完整的工程实例，并给出了处理后的单桩和单桩复合地基静载荷试验数据和沉降观测数据。
The load displacement curve under static load, load displacement hysteric curve under repeated low cycle load and strain data at key points are presented.
给出了静力荷载下的荷载变形曲线、低周反复荷载下的荷载变形滞回曲线以及关键部位的应变数据。
In this case, this paper researched on the clustering of data for load modeling and the modeling of the static load.
本文针对这种情况，对建模数据的聚类分析和静态负荷建模进行了研究。
The static load balancing strategy of parallel computing of the data-irregular problems with characteristic of boundary communication was discussed.
讨论以边缘通信为特征的数据不规则问题并行计算的静态负载平衡策略。
Based on historical data of Shaanxi natural gas network system, static and dynamic simulation and load forecasting of natural gas system has been researched in this thesis.
本文依据陕西省天然气管网系统的历史数据，对天然气管网系统稳动态仿真和天然气短期负荷预测进行了研究。
Many static test data indicate that, the load-transfer curves can be well fitted with hyperbola, so nonlinear analysis on behavior of load transferring along pile shaft is necessary.
大量试桩资料表明，桩身荷载传递函数曲线多符合双曲线模型，故有必要对基桩荷载传递性状进行非线性分析。
Based on part of the data of static load test, the ultimate bearing capacity and the whole load settlement curve is also predicted.
结合某根桩的静载试验结果，对该桩的荷载与沉降分别进行了预测，并在只有部分实测结果的情况下，对单桩的极限承载力进行了预测。
The condition and possibility of together use are also analyzed with static load test , train test and comparison among data, and some proposals are put …
在静载试验、动力应变测试、数据对比的基础上，对共同应用的条件及可能性进行了分析，并就出现的施工技术问题提出可行的处理方案。
The calculated results agree well with experiment data. It is proved that using static state contact arithmetic with ABAQUS software to simulate the pin load distribution is feasible.
分析计算结果与试验结果基本一致，说明采用该软件和静态接触算法来模拟计算钉载分配是可行的。
The calculated results agree well with experiment data. It is proved that using static state contact arithmetic with ABAQUS software to simulate the pin load distribution is feasible.
分析计算结果与试验结果基本一致，说明采用该软件和静态接触算法来模拟计算钉载分配是可行的。
应用推荐